搜索资源列表
pwnalready
- 已经调试通过的pwm程序点评：写这种程序要注意ACTRA的配置，还有死区的配置，防止爆管子。-has debugging procedures adopted by the PWM Comments : This procedure was necessary to pay attention to the configuration of ACTRA, there are dead zone configuration to prev
epwm_deadband
- TI DSP TMS320F280x PWM 死区控制例程。-TI DSP TMS320F280x PWM dead-zone control routines.
00000002
- 摘要：分析逆变器死区对输出电压的影响以及几种常用的补偿方法。-Abstract: Analysis of inverter dead-on the impact of the output voltage, as well as several commonly used methods of compensation.
siquwenxian
- dsp2812死区相关的文献非常全面，希望对大家有所帮助。-dsp2812 dead-zone-related literature is very comprehensive, and they hope to be helpful to everyone.
pwm
- easyARM8962 带死区控制的PWM控制操作源码-easyARM8962 with dead-zone control source PWM control operations
PWM
- 这是一种新型的PWM逆变技术，重点介绍死区的调节-This is a new type of PWM inverter technology, focusing on the regulation of dead zone
C8051F060_PWM_long
- 基于C8051F060单片机的PWM波形产生程序。 采用长整型计算，使用C8051F060内部的捕捉比较单元实现、使用专门的捕捉比较单元输出脚输出。 提供PWM波形频率、PWM波形占空比、双路PWM波形死区时间控制等功能。-Based on C8051F060 MCU PWM waveform generation process. Use of long integer calculations, use the C8051F
h
- 具有死区保护的H桥驱动电路，可以改为逆变电源，-H has a dead zone bridge driver circuit protection, power inverter can be changed,
PWM_DblEdg
- MCPWM 含有 3 个独立的通道，每个通道包括： 1 个32 位定时器/计数器（TC）； 1 个32 位界限寄存器（LIM）； 1 个32 匹配寄存器（MAT）； 1 个10 位死区时间寄存器（DT）和相应的 10 位死区时间计数器； 1 个32 位捕获寄存器； 2 个极性相反的已调整的输出
PWM2010-4-21
- simulink ,matlab 利用ePWMA和ePWMB产生互补的带有死区的PWM波对.
siqupwm
- PWM的死区控制模块CLK delaywave-PWM control module dead
epwm_deadband
- ti公司epwm模块死区设置功能代码，极具参考意义，-ti company epwm dead set function code module can directly call Thank you
pwm
- 带有死区的、频率可设置的PWM输出源码，实际中已经应用-With a dead zone, the frequency can be set in the PWM output source, have been applied in practice
STM32-M0-PWM互补输出和死区插入
- 利用STM32F031单片机产生六路相同频率具有死区时间的PWM，本程序可以用来做BLDC的参考(The use of STM32F031 microcontroller produces six same frequency, with dead time PWM, this procedure can be used to do BLDC reference)
DH
- 带有死区的hammerstein模型辨识(Identification of Hammerstein model with dead time)
7289-pwm死区
- 7289程序加按键产生pwm波，互补有死区(7289 program plus buttons to generate PWM wave, complementary dead zone)
三对6路PWM带互补带死区
- 应用stm32f103 输出6路pwm信号 还有互补和死区......(Application stm32f103 output 6 pwm signal there are complementary and dead zone)
stm32f103rc____PWM带死区
- stmf103rc 下四路pwm输出，带死区，能够用于全桥驱动。(Stmf103rc four road PWM output, with dead zone, can be used for full bridge drive.)
成功的 带死区的PWM输出
- stm32中一个带死区的PWM输出,可用于电机的驱动(a dead zone PWM output in stm32Can be used for motor drive)
死区互补pwm
- 基于stm32f403gz的互补带死区pwm程序，可以调用函数来实现自己pwm波形优化(The complementary dead band PWM program based on stm32f403gz can call functions to optimize its PWM waveform)