搜索资源列表
47-bujindianji-
- 1、本程序用于测试4相步进电机常规驱动 2、需要用跳帽或者杜邦线把信号输出端和对应的步进电机信号输入端连接起来 3、速度不可以调节的过快，不然就没有力矩转动了 4、按s4（设置成独立按键模式）可以控制正反转 -1, the procedure used to test the conventional 4-phase stepper motor driver 2, need to use DuPont wire j
5_SKEY
- 独立按键，按下不同的键，数码管显示0-3四个数字。-Independent keys, press the different keys, digital display four digits 0-3.
song
- 独立按键空着的唱歌程序 3个按键对应3首歌 可以随时切换-Independent program sing empty buttons 3 buttons correspond to the song can always switch 3
biansuliushuideng
- 独立按键控制4级变速流水灯程序，采用C语言编写的，开发环境为KEIL C，程序结构简单，通俗易懂，适合初学者学习-Independent key control 4 speed water light program, written using C language development environment for the KEIL C, the program structure is simple, user-friendl
6-dulianjian
- 51单片机汇编程序样例之，06独立按键，分享给大家。-Sample of 51 single-chip assembler, 06 independent keys to others.
ddddd
- 用c语言编写的单片机闹钟程序带有闹钟用矩阵键盘调试在按住独立按键K1时调闹钟-Microcontroller using c language alarm clock program with debugging in a matrix keyboard key press independence adjust the alarm clock when K1
pre-key
- 按键控制，检测独立按键，单片机读取状态口，控制相应的LED灯-Key control, testing the independent button, the microcontroller reads the status port and control the corresponding LED lights
C8051F120-ikey
- C8051F120单片机例程之独立按键，KEIL4环境下编译通过。-C8051F120 MCU routine independent keys, KEIL4 environment compile.
18Independent-key
- 单片机独立按键设计，涉及开关功能，这个是单片机基础编程要学的东西-SCM independent key design, involving switching function, the basis of this microcontroller is programmed to learn something
Digital-adjustable-dc-voltage-source
- STC89C52、1106AD、DAC0832 DA、1602液晶；步长0.1/1，可调范围1.24V~11.59V；误差5V以下0.02 以上0.02～0.3；用独立按键控制DA输出的数字量从而来调节输出电压，用AD检测输出电压并显示在液晶上 -STC89C52, 1106AD, DAC0832 DA, 1602 LCD steps of 0.1/1 adjustable 1.24V ~ 11.59V errors below 5
DS1302-Timer
- 1602显示的DS1302电子时钟，仅用3个独立按键即可调节时间-1602 shows the DS1302 electronic clock, only three independent keys to adjust the time
ScanKey
- 独立按键读取键值。通过扫描的方式把键值读取到单片机里-Independent key to read key. Way by scanning the chip inside the key to read
dianzhenmofangdiantixianshi
- 利用8x8LED点阵屏仿电梯数字滚动显示，带有8x8独立按键控制-Dot-matrix screen using 8x8LED imitation digital scroll elevator, with a 8x8 independent control keys
pwm
- 用avr16单片机，编译环境在ICC实现对pwm波的控制，为9位快速pwm波模式。通过两个独立按键能实现对占空比的调节。频率在20khz以上。-With avr16 microcontroller, compile environment in the ICC to realize the control of PWM waves, a fast PWM waves for 9 mode. Through the two indepen
interrupt
- 通过中断接口P3.3连接的独立按键测试，按一次P1.0口的LED灯反向， 作用效果和中断0相同，启用按键去抖，所以适合实际按键-P3.3 interrupt interface connected via a separate key test, according to a reverse P1.0 port of LED lights, and the effect of the same interrupt 0 Enable
ICCAVR_buttom_FSM_protues
- 使用状态机实现独立按键的程序，并用protues仿真，适用于avr单片机mega128-Using the state machine to achieve independence key procedures, and use protues simulation for avr microcontroller mega128
AD9850test3.0Serial
- 基于51单片机的AD9850控制程序。通过串行数据传输，只需四个IO口，相对并行数据传输要少7个IO。另外，通过四个独立按键设置输出频率值。如果滤波模块效果好，则输出40M正弦波波形良好！-Based on 51 single-chip AD9850 control procedures. Serial data transmission, only four IO ports, parallel data transfer to th
Verilog
- 基于Quartus II 9.0 (32-Bit)的Verilog语言时钟程序，五个独立按键分别可调十分秒的加减和确定，此程序通过硬件调试成功。-Based on Quartus II 9.0 (32-Bit) of the Verilog language, clock, five independent second key addition and subtraction, respectively, is adjustable
234
- c51独立按键的控制程序，很好的程序。和大家分享-c51 independent key control program, a very good program. And share
imitate-washing-machine
- 51单片机程序，独立按键控制继电器开关，通过控制2个继电器循环工作状态，模拟洗衣机间歇正反转 一般正转3s，停止2s，然后反转3s，停止2s，循环上述动作-51 single program, separate button control relay switches, relays cycle by controlling the two working condition, simulated washing machine