资源列表

« 1 2 ... .25 .26 .27 .28 .29 3030.31 .32 .33 .34 .35 ... 216384 »

[游戏引擎Fir20120918

说明:这是传奇飞尔世界的源码、完整的源码、自己测试过可以编译、控件稍后上传-This is a Seoul-source world, complete source code, you can compile your own tested, controls upload later
<zxmn> 在 2025-07-05 上传 | 大小:27.81mb | 下载:1

[游戏引擎FIR4Source

说明:这是国内开源、国外修改的飞尔世界、加入了传3和刺客、内置3界面、自己测试、编译能通过、完整的源码、控件稍后上传-This is the source, modify the Seoul foreign world, joined the mass 3 and assassins, built-in 3 interface, its own tests, compile pass, complete source code, controls, upload later
<zxmn> 在 2025-07-05 上传 | 大小:3.3mb | 下载:1

[其他小程序www.dssz.com_55593367lixijisuan

说明:用友财务软件没有利息计算功能,做了一个小程序。里面有导出电子表格功能。还能根据时间段自动算得平均日利息-Yongyou Software no financial interest calculation and made a small procedure. There are derived spreadsheets. Can automatically according to the time of day regarded average interest
<Liyu> 在 2025-07-05 上传 | 大小:5.21mb | 下载:1

[matlab例程lyapunov_gin

说明:求解Chen系统的最大lyapunov指数。求解方法为定义法。两条相轨线的步长为初设距离d0的基础上加上相对分量。求解时直接运行chen_lyapunov.m即可。可移植性强,比如换求其他系统的最大lyapunov指数,只需要改变变量数目,方程即可。-Solving the maximum lyapunov index Chen system. Solving method for defining method. Plus the relative weight of the two basi
<王海阳> 在 2025-07-05 上传 | 大小:1kb | 下载:1

[书籍源码dianzinengliangfenbu

说明:matlab编写的SF6/N2混合气体放电分析的程序,里面涉及蒙特卡洛法对混合气体的编写-SF6/N2 matlab prepared mixed gas discharge analysis procedure, which involves the Monte Carlo method for the preparation of the gas mixture
<王人> 在 2025-07-05 上传 | 大小:3kb | 下载:1

[书籍源码sf6_4mmguangdianli

说明:基于matlab编写的流体力学模型方法,研究SF6气体放电过程分析-Hydrodynamic model method matlab prepared based research SF6 gas discharge process analysis
<王人> 在 2025-07-05 上传 | 大小:5kb | 下载:1

[图形图像处理(光照,映射..)shuangxianxingchazhi

说明:关于分布式视频编码的边信息生成算法之双线性插值算法。-Distributed video coding side information about the bilinear interpolation algorithm to generate algorithms.
<二木> 在 2025-07-05 上传 | 大小:4kb | 下载:1

[单片机(51,AVR,MSP430等)AFGUI-master

说明:非常适合做单片机的GUI系统,占用内存小!-The GUI is very suitable for single-chip system
<yangou> 在 2025-07-05 上传 | 大小:1.29mb | 下载:1

[图形图像处理(光照,映射..)MATLAB_Program

说明:PM去噪模型的MATLAB代码,有参数选取,阀值的自由生成,并且是m.函数的形式,输入图像后可也自动进行运算处理,最后输出去噪后的图像。-MATLAB code PM denoising model, there are parameters selected, the freedom generation threshold, and is m. In the form of the function, the input image can also automatically after
<linmaoduian> 在 2025-07-05 上传 | 大小:17kb | 下载:1

[Internet/网络编程virtualrouter

说明:可以把无线网卡当作无线路由器使用,打开一个wifi热点,并能监控连接进来的电脑和手机等设备-virtual wifi router
<中国人> 在 2025-07-05 上传 | 大小:761kb | 下载:1

[matlab例程radar-signal

说明:包括相位编码(含二相BPSK和四相QPSK)、线性调频LFM、非线性调频NLFM、脉冲幅度调制(PAM)信号、带噪FSK频率编码信号等的信号源码,是很好的产生各种雷达信号的程序资源。-Including the phase encoding (including two-phase four-phase BPSK and QPSK), LFM LFM, non-linear FM NLFM, pulse amplitude modulation (PAM) signal with noise s
<liujia> 在 2025-07-05 上传 | 大小:10kb | 下载:1

[matlab例程QSGS

说明:采用四参数生成法自动生成多孔介质(二维),优化了出现独立单个节点、实体内部出现孔洞的问题-Four-parameter generation method automatically generates a porous medium, optimize the emergence of an independent single node, hole problems arise internal entities(2D)
<王婷婷> 在 2025-07-05 上传 | 大小:1kb | 下载:1
« 1 2 ... .25 .26 .27 .28 .29 3030.31 .32 .33 .34 .35 ... 216384 »

源码中国 www.ymcn.org