资源列表

« 1 2 ... .97 .98 .99 .00 .01 1902.03 .04 .05 .06 .07 ... 15240 »

[单片机(51,AVR,MSP430等)51Cprograme

说明:51单片机C语言应用程序设计实例精讲的源码程序,里面有protel格式的电路图和程序代码,希望对大家有帮助-51 Single-chip C language application design example精讲the source program, which has Protel format circuit diagram and program code, and they hope to have everyone help
<binlin> 在 2025-06-08 上传 | 大小:575kb | 下载:0

[单片机(51,AVR,MSP430等)maikuantiaozhi

说明:在p1.0上产生一个占空比变化的脉冲信号,它产生的脉宽调制信号用于电机的变速控制-err
<lvchuanwei> 在 2025-06-08 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)8255A

说明:单片机并口扩展芯片8255A源码,内服仿真文件和说明文件-Single-chip parallel port expansion 8255A chip source, internal simulation files and documentation
<辛愿> 在 2025-06-08 上传 | 大小:738kb | 下载:0

[单片机(51,AVR,MSP430等)TXD

说明:单片机通信源程序,为串口的发送和接收程序.-Single-chip communication source for the serial port of the sending and receiving procedures.
<ren> 在 2025-06-08 上传 | 大小:21kb | 下载:0

[单片机(51,AVR,MSP430等)Src-30F

说明:单相电机变频驱动原码,采用DISPIC30芯片-Single-phase motor inverter drive the original code, the use of chip DISPIC30
<lee> 在 2025-06-08 上传 | 大小:141kb | 下载:0

[单片机(51,AVR,MSP430等)LCD

说明:应用于ARM单片机的LCD1602的驱动代码-Applies to ARM MCU LCD1602 driver code
<吴炳志> 在 2025-06-08 上传 | 大小:2kb | 下载:0

[单片机(51,AVR,MSP430等)iic

说明:应用于ARM7单片机的UART源码,已通过调试-ARM7 MCU UART used source, has passed through debugging
<吴炳志> 在 2025-06-08 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)uart

说明:MAGIC2103-ARM7开发板中的UART源程序代码-MAGIC2103-ARM7 development board of the UART source code
<吴炳志> 在 2025-06-08 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)kongzhichengxu

说明:控制直流电机的c程序,大家看一下,做下点评,-C DC motor control procedures, look at everybody, to do under the comments,
<龙腾飞> 在 2025-06-08 上传 | 大小:30kb | 下载:0

[单片机(51,AVR,MSP430等)c805102xTBC

说明:转化为控制指令,然后每50ms通过串口向上位机发送一次命令,上位机收到数据后控制虚拟仿真机器人,最后,上位机收集虚拟机器人的姿态参数,再通过串-Translated into control commands, and then every 50ms upward through the serial-bit machine to send a command, the data received after the host computer to control the virtual si
<猫猫> 在 2025-06-08 上传 | 大小:218kb | 下载:0

[单片机(51,AVR,MSP430等)DS18B20

说明:便,且能进行大信息量的字符显示,还可以实现图形及曲线的显示,这就使人机接口更友好。当然,不同型号的液晶模块的内置控制器有很多种,各套指令也有一定差异, 但其设计思路和流程基本相同-Will be able to carry out large amount of information displayed characters, but also realize the display of graphics and curves, which is more friendly interfac
<猫猫> 在 2025-06-08 上传 | 大小:71kb | 下载:0

[单片机(51,AVR,MSP430等)LCD_ASCII

说明:大值的驱动电压,否则会造成液晶模块的损坏。如果在低于或大致等于典型驱动电压时,观察到了显示屏上有色调的变化,即显示域的底色略深于边缘的颜色,表明液晶模块电源连接正确,可以进人下一步工作。如-Large value of driving voltage, otherwise LCD module can cause damage. If less than or roughly equivalent to a typical drive voltage, the observed screen h
<猫猫> 在 2025-06-08 上传 | 大小:4kb | 下载:0
« 1 2 ... .97 .98 .99 .00 .01 1902.03 .04 .05 .06 .07 ... 15240 »

源码中国 www.ymcn.org