资源列表

« 1 2 ... .45 .46 .47 .48 .49 9850.51 .52 .53 .54 .55 ... 15240 »

[单片机(51,AVR,MSP430等)project20

说明:抢答器的两个按键一个是设置清除键一个是开始键,按照抢答流程,可以实现简易8路抢答功能 (哈工大单片机大作业内附proteus原理图)-Two keys Responder is to set a clear key is a start key, in accordance with the the Responder process can be simple 8-way Responder (HIT SCM operations included proteus schematic)
<邹sir> 在 2025-06-29 上传 | 大小:65kb | 下载:0

[单片机(51,AVR,MSP430等)project24

说明:单片机的定时器产生秒信号,控制十字路口的红、绿、黄灯交替点亮和熄灭,并且用4只LED数码管显示十字路口两个方向的剩余时间。要求能用按键设置两个方向的通行时间(绿、红灯点亮时间)和暂缓通行时间(黄灯点亮的时间)(哈工大单片机大作业内附proteus原理图)-The microcontroller timer generates a second signal to control the crossroads of red, green, the yellow alternately turned
<邹sir> 在 2025-06-29 上传 | 大小:67kb | 下载:0

[单片机(51,AVR,MSP430等)project29

说明:利用定时器T1的中断来使P1.7控制蜂鸣器发出1kHz的音频信号,系统时钟为12MHz(哈工大单片机大作业内附proteus原理图)-Timer T1 interrupt P1.7 control buzzer audio signal of 1 kHz system clock 12MHz (HIT the microcontroller large job included proteus diagram)
<邹sir> 在 2025-06-29 上传 | 大小:51kb | 下载:0

[单片机(51,AVR,MSP430等)project31

说明:把电话键盘中拨出的某一电话号码,显示在LCD显示屏上。电话键盘共有12个键, 除了0-9的10个数字键外,还有“*”用于实现删除功能,即删除最后一位输入的号码;“#”用于清除显示屏上所有的数字显示。还要求每按下一个键要发出声响,以表示按下该键。(哈工大单片机大作业内附proteus原理图)-Allocated telephone keypad of a phone number is displayed on the LCD display. A total of 12 key telep
<邹sir> 在 2025-06-29 上传 | 大小:59kb | 下载:0

[单片机(51,AVR,MSP430等)project40

说明:甲机的K1按键可通过串口控制乙机的LED1点亮,LED2灭,甲机的K2按键控制乙机的LED1灭,LED2亮,甲机的K3按键控制乙机的LED1和LED2全亮。乙机的K2按键可控制串口向甲机发送按下的次数,按下的次数通过串口显示在甲机P0口的数码管上。(哈工大单片机大作业内附proteus原理图)-A machine K1 keys can be lit through serial control acetic machine LED1, LED2 off, A machine K2 keys t
<邹sir> 在 2025-06-29 上传 | 大小:76kb | 下载:0

[单片机(51,AVR,MSP430等)project45

说明:5个开关K1-K5(从上到下),分别对应正弦波、方波、三角波、梯形波、锯齿波,按一下其中一个开关,则选择出所要产生的波形。(哈工大单片机大作业内附proteus原理图)-5 switch K1-K5 (top to bottom), corresponding to the sine wave, square wave, triangle wave, trapezoidal wave, sawtooth, click one of the switch, and then select the
<邹sir> 在 2025-06-29 上传 | 大小:87kb | 下载:0

[单片机(51,AVR,MSP430等)project48

说明:单片机采用中断方式,对2路0-5V的模拟电压进行循环采集,采集的数据送LED交替显示,并存入内存。超过界限时指示灯闪烁。(哈工大单片机大作业内附proteus原理图)-Microcontroller interrupt loop acquisition of 2-way 0-5V analog voltage data collected to send the LED alternately displayed and stored in the memory. Indicator flash
<邹sir> 在 2025-06-29 上传 | 大小:67kb | 下载:0

[单片机(51,AVR,MSP430等)dingshizhongduan

说明:51单片机汇编实现定时中断,使用多个计时器和中断器-The 51 MCU compilation timer interrupt use more than one timer and interrupt controller
<丁路> 在 2025-06-29 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)VB-AVR

说明:VB程序实现与AVR单片机的通讯,来控制单片机的IO。-VB communication with avr
<张悦> 在 2025-06-29 上传 | 大小:2.63mb | 下载:0

[单片机(51,AVR,MSP430等)LED

说明:stm32 arm7控制led灯,跑马灯实验程序-the stm32 control led, Marquee experimental program
<liulishuang> 在 2025-06-29 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)led88

说明:8*8矩阵原理,及其代码,有汇编,也有c的-8* 8 matrix theory, its code, compilation, also c
<黄友霖> 在 2025-06-29 上传 | 大小:47kb | 下载:0

[单片机(51,AVR,MSP430等)stm32-usart

说明:STM32F103RBt6的串口通讯例程,采用寄存器方式实现。-STM32F103RBt6 serial communication routines, achieved register.
<weiqianghgd> 在 2025-06-29 上传 | 大小:625kb | 下载:0
« 1 2 ... .45 .46 .47 .48 .49 9850.51 .52 .53 .54 .55 ... 15240 »

源码中国 www.ymcn.org