资源列表
[单片机(51,AVR,MSP430等)] SHIZHONGBUYONGZONGDUAN
说明:基于51系统的时钟程序,采用外中断调整时间,便于初学者学习使用。-51 system clock based procedure to adjust the time by external interrupt, easy for beginners to learn to use.<李逍遥> 在 2025-06-23 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] c8051f021_AD
说明:基于c8051f021单片机的AD采样程序,并判断AD采样值。-Microcontroller based c8051f021 AD sampling procedures, and determine the value of AD samples.<胡雪> 在 2025-06-23 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] c8051f021_1602
说明:基于c8051f021的液晶显示程序,可以在1602液晶的第二行显示一个时钟。-LCD display program based on c8051f021, 1602 LCD in the second line displays a clock.<胡雪> 在 2025-06-23 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] AD_DA
说明:基于AT89S52单片机的AD和DA连调程序,AD使用ADC0832,DA使用TLC5615,调整DA可以改变灯的亮度,并改变AD的采样值。-AT89S52 Microcontroller based on AD and DA with transfer procedures, AD using the ADC0832, DA use TLC5615, DA can be changed to adjust the brightness of light, and change the valu<胡雪> 在 2025-06-23 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] keyscan32.c
说明:c51编写的32个键盘的扫描程序,可以参考此程序,写出所有的键盘扫描程序-scan 32 keys,using C51。you can learn this program to write other high qunity of codes<xiaoli> 在 2025-06-23 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] crc
说明:这是CRC16的代码,有需要的朋友可以看看啊,。是VB6.0的代码-This is the CRC16 code, there is need of a friend can see, ah. Is the VB6.0 code<李利> 在 2025-06-23 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] led
说明:利用动态扫描和定时器1在数码管上显示 出从765432开始以1/10秒的速度往下递减 直至765398并保持显示此数,与此同时利 用定时器0以500MS速度进行流水灯从上至 下移动,当数码管上数减到停止时,实验 板上流水灯也停止然后全部开始闪烁,3秒 后(用T0定时)流水灯全部关闭、数码管上 显示出"HELLO",并保持-Dynamic scan and Timer 1 in the digital pipe shows start from 765 432 to 1<景剑飞> 在 2025-06-23 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] 3_3
说明:同时用两个定时器控制蜂鸣器发声, 定时器0控制频率,定时器1控制同个 频率持续的时间,间隔2s依次输出 1,10,50,100,200,400,800, 1k(hz)的方波。设晶振频率为12MHz。-At the same time the buzzer sound with two timers, Timer 0 control the frequency of Timer 1 control with a frequency, duration, interval 2s tu<景剑飞> 在 2025-06-23 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] 2_7
说明:间隔300ms先奇数亮再偶数亮, 循环三次;一个灯上下循环三次; 两个分别从两边往中间流动三次; 再从中间往两边流动三次;8个全部闪烁3次; 关闭发光管,程序停止。-Interval of 300ms the first odd and then even bright light, cycle three times a light cycle up and down three times two separate flow from both sides to the<景剑飞> 在 2025-06-23 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] bujindianji
说明:基于单片机的步进电机的控制,实现对步进电机的简单控制-Microcontroller-based stepper motor control of stepper motor' s simple control<沐霖> 在 2025-06-23 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] spi
说明:基于单片机的通过spi控制语音芯片,实现录音、播放等功能-Spi-based Microcontroller controlled by voice chip, to achieve recording, playback and other functions<沐霖> 在 2025-06-23 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] jingqueyanshi
说明:用c51写的很精确的延时程序,只要带入要延时的参数就可以实现很精确的延时。-In the very accurate c51 written procedures, as long as the delay to delay into parameters can be realized very accurate delay.<junhong> 在 2025-06-23 上传 | 大小:1kb | 下载:0