资源列表

« 1 2 ... .48 .49 .50 .51 .52 8853.54 .55 .56 .57 .58 ... 15240 »

[单片机(51,AVR,MSP430等)adc0832

说明:c8051学习机实验程序,在12MHz晶振下测得。-C8051 machine learning experimental procedures, the 12MHz crystal measured.
<李方> 在 2025-11-15 上传 | 大小:27kb | 下载:0

[单片机(51,AVR,MSP430等)zhinengchoushui

说明:开发环境Keil 51,mcu: 89s51,显示用 LCD 1602 液晶显示模块。-Development environment Keil 51, mcu: 89s51, used LCD 1602 LCD Module.
<fy> 在 2025-11-15 上传 | 大小:27kb | 下载:0

[单片机(51,AVR,MSP430等)I2C_24C16

说明:lpc2300系列ARM驱动24c16存储器的源程序-LPC2300 family of ARM-driven source memory 24c16
<合金弹头> 在 2025-11-15 上传 | 大小:27kb | 下载:0

[单片机(51,AVR,MSP430等)I2C_24C256

说明:lpc2300系列ARM驱动24c256存储器的源程序 比24c16容量大-LPC2300 Series ARM driver 24c256 source memory capacity than 24c16
<合金弹头> 在 2025-11-15 上传 | 大小:27kb | 下载:0

[单片机(51,AVR,MSP430等)F149_NRF2401V1.1

说明:MSP430F149上NRF2401的程序demo,注释详细-MSP430F149 on nRF2401 procedure demo, detailed notes
<pihui> 在 2025-11-15 上传 | 大小:27kb | 下载:0

[单片机(51,AVR,MSP430等)ds1302a

说明:3、LCD12864不能显示或不能清楚显示: 1)重新按住复位键和KEY A 2)或者:调整可调电阻。调到合适的亮度。 3)或者:冷启动。 4)或者:检查是否有其他按键按下,如红外接收头旁边的INT0按键是否压下。如压下,请弹起。 5)或者:温度传感器芯片是否拔出。如没有拔出,请拔出。重新复位并按住KEY A。-3, LCD12864 should not show or can not be clearly demonstrated: 1) Hold down the reset button
<段威吉> 在 2025-11-15 上传 | 大小:27kb | 下载:0

[单片机(51,AVR,MSP430等)I2C

说明:接收串口发来的数据,写到24C02里面,再从24C02里读出刚写进的数据,由串口发出-Receive serial data sent, wrote 24C02 inside, and then read out from a 24C02 just been included in the data sent from serial port
<shine> 在 2025-11-15 上传 | 大小:27kb | 下载:0

[单片机(51,AVR,MSP430等)Programable_Amplifier

说明:使用DAC0832做的程控衰减器,51单片机驱动-DAC0832 do use the program-controlled attenuator, 51 single-chip driver
<> 在 2025-11-15 上传 | 大小:27kb | 下载:0

[单片机(51,AVR,MSP430等)LCM067

说明:LCM067的驱动程序,由51单片机驱动-LCM067 drivers, from 51 single-chip driver
<> 在 2025-11-15 上传 | 大小:27kb | 下载:0

[单片机(51,AVR,MSP430等)I2C_24C16

说明:在PHILIPS ARM7 LPC214x读写AT24C16,KEIIL环境下编译-PHILIPS ARM7 LPC214x in read and write AT24C16, KEIIL compiler environment
<陈卡卡> 在 2025-11-15 上传 | 大小:27kb | 下载:0

[单片机(51,AVR,MSP430等)11122222333

说明:采用PC机实现单片机优化控制-Using PC-to achieve optimal control of single-chip microcomputer
<> 在 2025-11-15 上传 | 大小:27kb | 下载:0

[单片机(51,AVR,MSP430等)LBT-FC8B

说明:用于单白色144颗LED8段追光,输出为SPI格式,使用的芯片是ATTINY2313V-10PU -144 for single white light up LED8 paragraph, the output for the SPI format, the use of the chip is ATTINY2313V-10PU
<龙天文> 在 2025-11-15 上传 | 大小:27kb | 下载:0
« 1 2 ... .48 .49 .50 .51 .52 8853.54 .55 .56 .57 .58 ... 15240 »

源码中国 www.ymcn.org