资源列表
[单片机(51,AVR,MSP430等)] 08528
说明:最简单片机系统的测试程序,端口的电平操作,基于89C2051的电压采样程序,单片机控制语音芯片的例程,usb,串口等单片机相关例程-The most simple single-chip microcomputer system testing procedures, port-level operation, the voltage 89C2051-based sampling procedures, single-chip control routines voice chip, usb,<gelei> 在 2025-06-13 上传 | 大小:1.24mb | 下载:0
[单片机(51,AVR,MSP430等)] dingshiqi
说明:利用单片机内置的定时器实现定时时间到后产生中断功能-The use of single-chip built-in timer to achieve timing<marry> 在 2025-06-13 上传 | 大小:3kb | 下载:0
[单片机(51,AVR,MSP430等)] dianzizhong
说明:利用单片机实现模拟电子时钟在数码管上显示分秒-The use of single-chip analog clock in the digital electronic control display minutes and seconds<marry> 在 2025-06-13 上传 | 大小:5kb | 下载:0
[单片机(51,AVR,MSP430等)] 51display
说明:51系列单片机在LCM上的显示程序,应该有广泛的借鉴意义-51 Series single-chip display in the LCM procedure, there should be a wide range of reference<海天> 在 2025-06-13 上传 | 大小:4kb | 下载:0
[单片机(51,AVR,MSP430等)] v311_5408AD
说明:STC12C5408AD单片机通过SPI接口实现对语音芯片ISD1700的操控。该源码为实验程序,供参考。-Single-chip STC12C5408AD through the SPI interface to control the ISD1700 voice chip. The source for the experimental procedure, for reference.<zhao> 在 2025-06-13 上传 | 大小:2kb | 下载:0
[单片机(51,AVR,MSP430等)] msp430x54x_flashwrite_04
说明:MSP430x54x Flash读写代码-MSP430x54x Flash write sample code<ZY> 在 2025-06-13 上传 | 大小:27kb | 下载:0
[单片机(51,AVR,MSP430等)] dingshi
说明:两个定时实验,1.具体要求:采用定时器T0的溢出中断,单片机P1.0接发光二极管LED0。T0的每一次中断,在中断处理程序中都会对LED0的状态做一次改变(P1.0输出信号进行反转)。 2.具体要求:定时器T1每0.05秒中断一次,单片机P1口接8个发光二极管LED0~LED7,编写程序,使发光二极管有规律地循环点亮。例如:开机后,第一秒钟LED0、LED2亮,第二秒钟LED1、LED3亮,第三秒钟LED4、LED6亮,第四秒钟LED5、LED7亮,第五秒钟LED0、LED2、LED4、LE<scarly> 在 2025-06-13 上传 | 大小:77kb | 下载:0
[单片机(51,AVR,MSP430等)] RTC_Workaround
说明:MSP430x54x 实时时钟示例代码-MSP430x54x RTC sample code<ZY> 在 2025-06-13 上传 | 大小:206kb | 下载:0
[单片机(51,AVR,MSP430等)] kuozhancunchu
说明:设计一个程序,向62256的0000H~0013H存储单元里依次连续 写 入数据1到20。接着依次再从这些单元中读出这20个数,并求这20个数的累加和(结果应为D2H),将其通过P1口送出(仿真电路中的发光二极管D1~D8)。-Design a program to 62,256 of the 0000H ~ 0013H memory cell in order to write the data for 1-20. Followed by a further unit from the rea<scarly> 在 2025-06-13 上传 | 大小:61kb | 下载:0
[单片机(51,AVR,MSP430等)] waibuzhongduan
说明:采用外部中断INT0(用按键BUTTON模拟)中断,单片机P2口为输出口外接两位LED数码管。每申请一次中断(按下BUTTON),在中断处理程序中对数码管的显示数据作加1改变(实验中P2口外接的两位LED数码管采用7447硬件译码的方式以BCD码显示)。-The use of external interrupt INT0 (with simulated BUTTON button) interrupt, microcontroller P2 output port for an externa<scarly> 在 2025-06-13 上传 | 大小:49kb | 下载:0
[单片机(51,AVR,MSP430等)] infrared_remote_control_information
说明:单片机红外遥控综合资料,包含各类电视遥控协议,C语言和汇编语言解码范例程序-Comprehensive information on single-chip infrared remote control, including all kinds of TV remote control protocol, C language and assembly language sample program decoder<张治积> 在 2025-06-13 上传 | 大小:1.31mb | 下载:0
[单片机(51,AVR,MSP430等)] AT90USB162_USB_Magnetic_IC_card_reader
说明:AT90USB162_USB磁卡刷卡器IC卡读写程序-USB_Magnetic_IC_card_reader<maoxin> 在 2025-06-13 上传 | 大小:1.43mb | 下载:0