资源列表

« 1 2 ... .60 .61 .62 .63 .64 2265.66 .67 .68 .69 .70 ... 3400 »

[数学计算/工程计算Ber_ldpc

说明:The documents include a few more LDPC by C-The documents include a few more LDPC by C++
<mehdi> 在 2025-09-17 上传 | 大小:3.51mb | 下载:0

[数学计算/工程计算fuzzy

说明:Code of Fuzzy Logic Method
<Anson> 在 2025-09-17 上传 | 大小:1kb | 下载:0

[数学计算/工程计算jinzhi

说明:tc实现了2-36进制的任意转换。多进制转十进制用的是按权展开,十进制转多进制用的是倒取余数。 注:10进制以上,分别用A表示10、B表示11、以此类推……参数中的n是进制数。-Achieve a 2-36 hex any conversion. Ary turn is based on the right of the decimal to start using decimal ary turn is used to take down the remainder. NOTE: mo
<聂国军> 在 2025-09-17 上传 | 大小:1kb | 下载:0

[数学计算/工程计算NBTool

说明:AES的解密工具,支持ECB、CBC、OFB、等等模式。密钥长度不固定。来自Openssl的aes算法。绝对正确。-AES decryption tool that supports ECB, CBC, OFB, etc. mode. Key length is not fixed. Aes Openssl algorithm. Absolutely right.
<ziolo> 在 2025-09-17 上传 | 大小:2.7mb | 下载:0

[数学计算/工程计算Surface

说明:利用最速下降法计算最小曲面的面积,初始条件为0,边界条件为正方形固定边界。-Using steepest descent method to calculate the minimum surface area. Initial condition is 0, while boundary condition is square fixed values.
<weiqiang> 在 2025-09-17 上传 | 大小:1kb | 下载:0

[数学计算/工程计算YICHUAN

说明:基于遗传算法的阵列信号幅相误差校正,通过遗传算法来校正阵元通道的幅度误差和相位误差-Correction of genetic algorithm based on array signal amplitude and phase error, amplitude error by genetic algorithm to calibrate the sensor channel and phase error
<杨光> 在 2025-09-17 上传 | 大小:4kb | 下载:0

[数学计算/工程计算cavity

说明:Fortran code for solving Lid-Driven cavity
<zikou> 在 2025-09-17 上传 | 大小:1kb | 下载:0

[数学计算/工程计算diffu

说明:Solving Turbojet Diffuser Desing Code of Fortran 90
<zikou> 在 2025-09-17 上传 | 大小:1kb | 下载:0

[数学计算/工程计算Interpolation

说明:Fortran code to interpolating mathemathical fluid properties
<zikou> 在 2025-09-17 上传 | 大小:1kb | 下载:0

[数学计算/工程计算3G

说明:This lTE simulation.-This is lTE simulation.
<suneet> 在 2025-09-17 上传 | 大小:3kb | 下载:0

[数学计算/工程计算Runge_Kutta

说明:龙格-库塔(Runge-Kutta)方法是一种在工程上应用广泛的高精度单步算法。由于此算法精度高,采取措施对误差进行抑制,所以其实现原理也较复杂。该算法是构建在数学支持的基础之上的。数值计算中经常用到,四阶龙格库塔经常被称为“RK4”或者就是“龙格库塔法”。-Runge- Kutta (Runge-Kutta) method is a widely used in engineering high-precision single-step algorithm. Due to the high
<yangxu> 在 2025-09-17 上传 | 大小:12kb | 下载:0

[数学计算/工程计算chuneng_Charge

说明:对蓄电池的控制策略在matlab中进行建模-Control strategy of storage battery are modeled in the matlab
<mingzhang> 在 2025-09-17 上传 | 大小:22kb | 下载:0
« 1 2 ... .60 .61 .62 .63 .64 2265.66 .67 .68 .69 .70 ... 3400 »

源码中国 www.ymcn.org