资源列表

« 1 2 ... .29 .30 .31 .32 .33 734.35 .36 .37 .38 .39 ... 968 »

[其他行业ANIMATION_LAYER

说明:GIS软件,动态图层,很好玩的,在上面放一部车,设置车的属性还有起点和终点,车就能动起来-GIS software, dynamic layers, is a lot of fun, in the above release a car, a provision also attributes the starting point and end point, cars will be able to move
<林澍欣> 在 2025-06-15 上传 | 大小:7kb | 下载:0

[其他行业pfc_NR

说明:% 该Matlab程序基于牛顿-拉夫逊算法,用于计算已知导纳矩阵、PQ节点、PV节点、平衡节点(UA)的电力网络潮流 % U - 各节点母线电压 S - 各节点注入功率 S_net - 电力网络总损耗 % PQ_P - 实算PQ节点注入有功功率 PQ_Q - 实算PQ节点注入无功功率 % delt_PQ_P - 实算PQ节点有功功率修正值 delt_PQ_Q -实算PQ节点无功功率修正值 % delt_UA_P - 实平衡节点有功功率修正值 delt_U_2 - 实平衡节点电压平
<mmcc> 在 2025-06-15 上传 | 大小:7kb | 下载:0

[其他行业PQPOWERFLOWSOLUTION

说明:基于PQ分解法的电力系统潮流计算,计算速度优于基于牛顿法的潮流计算程序-PQ decomposition method based on the power flow calculation speed is better than Newton's law on the procedures for calculating the tide
<山东> 在 2025-06-15 上传 | 大小:7kb | 下载:0

[其他行业gas_simulation

说明:气体反吹模拟程序,采用C++Builder 编写,对开阀得瞬间气体的流动进行模拟-gas cleaning simulation procedures and the preparation of C Builder, off valve in the gas instantaneous flow simulation
<秦泽天> 在 2025-06-15 上传 | 大小:7kb | 下载:0

[其他行业convex_vb

说明:凸包最常用的凸包算法是Graham扫描法和Jarvis步进法.本程序用Graham扫描法实现凸包的绘制-convex hull of the most commonly used convex hull algorithm is scanning and Graham Jarvis stepping law. The procedures used G raham scanning method to achieve the convex hull mapping
<gaici> 在 2025-06-15 上传 | 大小:7kb | 下载:0

[其他行业DZC

说明:水泥厂的粉煤灰电子称程序,有校称,除皮,缺料报警,卡料报警等模块。-Fly ash cement, said electronic procedures, the school said that in addition to skin, shut warning, alarm and other card feed module.
<ZB> 在 2025-06-15 上传 | 大小:8kb | 下载:0

[其他行业TriFem

说明:悬臂梁三角形单元集中荷载作用下端部位移,适用一般单元-悬臂梁三角形单元集中荷载作用下端部位移,适用一般单元 悬臂梁三角形单元集中荷载作用下端部位移,适用一般单元 The displacement of the lower part of the cantilever beam triangular element under concentrated load is suitable for the general element
<A> 在 2025-06-15 上传 | 大小:8kb | 下载:0

[其他行业Time History Analysis Program For SDOF System

说明:Time History Analysis Program For SDOF System
<guobinbu> 在 2025-06-15 上传 | 大小:8kb | 下载:0

[其他行业OKB430.tar_31089

说明:pfsense for thin clinets
<Cacti> 在 2025-06-15 上传 | 大小:8kb | 下载:0

[其他行业FX_keyreader

说明:unlock plc mitsubishi
<pam_atw> 在 2025-06-15 上传 | 大小:8kb | 下载:0

[其他行业P3

说明:皮尔逊Ⅲ型适线软件,MATLAB编程,GUI,可修改(Pearson-III distribution,Optimum line software,MATLAB,GUI)
<Strayer_> 在 2025-06-15 上传 | 大小:8kb | 下载:1

[其他行业gbl

说明:结构设计软件插件可以改板筋gbj,施工图绘制,施工图出图
<921308538@qq.com> 在 2021-04-23 上传 | 大小:7.18kb | 下载:0
« 1 2 ... .29 .30 .31 .32 .33 734.35 .36 .37 .38 .39 ... 968 »

源码中国 www.ymcn.org