资源列表
[书籍源码] danfaduoshou
说明:无线通信信道仿真,单发多收。发送天线到不同接收天线的信道独立-Wireless communication channel simulation, single overcharged. Send an antenna to a different receiving antenna independent channel<lu_xy> 在 2025-07-13 上传 | 大小:1kb | 下载:0
[汇编语言] vb
说明:首先判断给出的3条边能否构成三角形。如可以构成。则计算并输出该三角形的面积,否则要求重新输入。当输入-1时结束程序-First of all, given to determine whether the three constitute a triangle edge. Such as may constitute. Are calculated and output in the triangle area, and failing that, to re-enter. When you e<tom> 在 2025-07-13 上传 | 大小:1kb | 下载:0
[语音合成与识别] soundin
说明:% this a experiment that input is done using the sound card %2003,6,3 %Usage:[second,voltage,frequency,magnitude]=soundin (VoiceFrequencyFactor,rate) %VoiceFrequencyFactor is set as 1/8 and rate as 8000, when the Frequency is % below 40hz ro<ming> 在 2025-07-13 上传 | 大小:1kb | 下载:0
[汇编语言] STC12C5412ADADCandUART
说明:在KEILC下实现STC12C5412AD的三通道A/D转换程序,并用串口显示,软硬件结合,调试通过,程序稳定,请放心使用,并多提意见。由于本人以前用的是汇编开发,现刚改为C,所以可能程序不是很地道。-KEILC under STC12C5412AD in the three-channel A/D conversion process, and serial shows that combination of hardware and software, debugging is passed<李文强> 在 2025-07-13 上传 | 大小:1kb | 下载:0
[书籍源码] 123
说明:被控对象为一个三环结构的伺服系统。伺服系统参数和控制参数在程序中给出描述。系统采样时间为1ms.根据是否加入摩擦干扰和前馈补偿分别进行仿真。-Charged for a three-ring structure of the servo system. Servo system parameters and control parameters described in the procedure are given. System sampling time of 1ms. In accord<maoxuefei> 在 2025-07-13 上传 | 大小:1kb | 下载:0