资源列表

« 1 2 ... .16 .17 .18 .19 .20 121.22 .23 .24 .25 .26 ... 319 »

[并行运算Pthread-to-caculate-PI

说明:并行计算课程实验,多线程计算π,采用了加锁法以及数组暂存解决数据同步问题。-Experimental parallel computing course, multi-threaded computing π, using an array of temporary lock method and solve the data synchronization.
<YUANZX> 在 2025-06-24 上传 | 大小:2kb | 下载:0

[并行运算mi

说明:IC read and wire soft -this is IC read and write
<zhangy> 在 2025-06-24 上传 | 大小:74kb | 下载:0

[并行运算mehmet

说明:Gaussian Elimination with MPI
<mehmet> 在 2025-06-24 上传 | 大小:3kb | 下载:0

[并行运算clk

说明:二分之一分频器及其测试程序,是用modelsim仿真实现-One half of the divider and the test procedure is used modelsim Simulation
<张依> 在 2025-06-24 上传 | 大小:1kb | 下载:0

[并行运算BFJacobismoother

说明:块迭代的阻尼雅克比松弛方法,对大型稀疏的线性方程组非常有效。-Block iterative relaxation method than the resistance Ni Yake
<ylw> 在 2025-06-24 上传 | 大小:1kb | 下载:0

[并行运算matriz.c.tar

说明:vcbhdfg dfg dfg dfg df gdf g-vcbhdfg dfg dfg dfg dfg dfg dfg df gdfgdfg
<laura> 在 2025-06-24 上传 | 大小:2kb | 下载:0

[并行运算archivo-nuevo.tar

说明:ghj vgn f gn f gn f fgn f-ghjghj vgn fgn fgn fgn fgn f fgn f
<laura> 在 2025-06-24 上传 | 大小:1kb | 下载:0

[并行运算p2.34

说明:计算练习:要求使用者输入每组运算的题量和出现数字的最大值,然后计算出随机出的计算题.电脑最后给出正确率.-Calculation exercises: ask the user to input the amount of each operation and the emergence of problems the maximum number, and then calculate the random out of the math. Finally, the accuracy of t
<Cquestioner> 在 2025-06-24 上传 | 大小:1kb | 下载:0

[并行运算prime2

说明:使用MPI库的并行求一组连续整数中有多少素数程序-a program to get the numbers of how many primes in a set of natural numbers with mpi library
<xu> 在 2025-06-24 上传 | 大小:1kb | 下载:0

[并行运算constrainedcircle

说明:研究各种拟合圆的方法,提出了一个圆的代数距离表示法的系数约束条件,在此约束条件下讨论圆的几何特征参数的估计问题,并给出了特征参数在约束条件下的最小二乘估计.实例验证表明,文中算法比一般最小二乘法具有更高的拟合精度. -Various methods of fitting a circle, a circle is proposed algebraic representation of the coefficient of distance constraints, under the co
<pzg> 在 2025-06-24 上传 | 大小:1kb | 下载:0

[并行运算calcCircle

说明:calcCircle.m程序采用通过三点来拟合一个圆,可以得到圆的关键参数(圆心坐标和半径)。-Fitting circle through three points
<pzg> 在 2025-06-24 上传 | 大小:1kb | 下载:0

[并行运算convhull

说明:设平面上n个点为 ,坐标原点为 。可按照下面方法求得包含这n个点的凸多边形。 (1)求最右边点,即x坐标最大点,设为 。 (2) 以 点为中心,在其余 个点中选取与 逆时针旋转角度最小的点,设为 。 (3)再以 点为中心,在其余 个点中选取与 逆时针旋转角度最小的点 。如此类推,直到新选取的点与 点重合为止。设已求得多边形k个点依次为 ,其中第 点与第1点重合。则分别以点 为三角形顶点计算面积并求和即可。 -Let n points in the plane as the
<pzg> 在 2025-06-24 上传 | 大小:26kb | 下载:0
« 1 2 ... .16 .17 .18 .19 .20 121.22 .23 .24 .25 .26 ... 319 »

源码中国 www.ymcn.org