资源列表
[LabView] solen-experiment
说明:DAQ模块的可重触发,可以用来监测四路模拟信号的电平-DAQ module can be re-triggered, can be used to monitor the four analog signal level<何海龙> 在 2025-07-14 上传 | 大小:703kb | 下载:0
[LabView] simple-trigger-event
说明:这是一个测量扭矩的Labview测试平台程序,每当确定数量的采样完成时,事件结构就会触发,结构内部的处理程序就会运行。如果信号出现异常,就会停止下来。当按下调试按钮之后,程序又会跑起来。-This is a measurement of torque Labview test platform program, complete Whenever determine the number of sampling, the event structure will trigger the stru<何海龙> 在 2025-07-14 上传 | 大小:102kb | 下载:0
[LabView] LabVIEW-vi
说明:LabVIEW宝典所有课件和该书每章中所有的VI程序-LabVIEW canon all courseware and book each chapter VI program<罗知亮> 在 2025-07-14 上传 | 大小:27.13mb | 下载:0
[LabView] LabVIEW-examples
说明:许多LabVIEW的实例,VI可以直接运行的,可以通过程序来实战-Many LabVIEW instance, VI can be run directly by the program to combat<罗知亮> 在 2025-07-14 上传 | 大小:5.14mb | 下载:0
[LabView] LabVIEW-codes
说明:LabVIEW 智能游戏源代码,运行通过-LabVIEW intelligent game source code, run through<罗知亮> 在 2025-07-14 上传 | 大小:28.46mb | 下载:0
[LabView] Data-acquisition
说明:labview 多通道数据采集监测系统 内附程序说明和描述-labview multi-channel data acquisition monitoring system included the descr iption of the procedures and descr iption<罗知亮> 在 2025-07-14 上传 | 大小:1.14mb | 下载:0
[LabView] Autocorrelation
说明:基于labview的多重自相关算法测量低信噪比条件下两路正弦波的相位差-Based on the phase difference between two sine wave labview multi the autocorrelation algorithm measuring low signal-to-noise ratio conditions<罗知亮> 在 2025-07-14 上传 | 大小:22kb | 下载:0
[LabView] Cross-correlation
说明:基于labview8.6的FFT法测量低信噪比条件下两路方波信号的相位差,经测试,幅值测量精度和相位测量精度都很高-Based labview8.6 FFT method to measure the phase difference between the two square wave signals in low signal-to-noise ratio conditions, test, amplitude measurement accuracy and phase measurem<罗知亮> 在 2025-07-14 上传 | 大小:51kb | 下载:0
[LabView] Digital-phase-sensitive-detector
说明:基于labview8.6的数字相敏检波算法源码,高精度实现测量低信噪比条件下正弦波幅值和初相的测量-Sine wave amplitude and the initial phase of the measuring low signal-to-noise ratio under the conditions measurement labview8.6-based digital phase-sensitive detection algorithm source, high-precisio<罗知亮> 在 2025-07-14 上传 | 大小:19kb | 下载:0
[LabView] Serial-port-data-acquisition-system-
说明:本系统利用单片机通过串口和数字化的温度传感器18b20对温度进行采集和监控,通过串口通信可以将采集的温度数据传给电脑,利用电脑进行数据处理和显示,包括保存和回放数据,回放数据速度可进行调整。-The system microcontroller through serial port and the digital temperature sensor<曾雯浩> 在 2025-07-14 上传 | 大小:38kb | 下载:0