资源列表

排序选择:

« 1 2 ... .02 .03 .04 .05 .06 215907.08 .09 .10 .11 .12 ... 267468 »

[matlab例程preprocess

说明:N4ITK Bias Correction. this code is usefull for MRI bias Field removing.
<homan> 在 上传 | 大小:10kb | 下载:0

[软件工程PCF8563

说明:用51单片机和时钟pcf8563制作电子钟方案,对初学者有帮助-51 And with the clock pcf8563 making electronic clock program, to help beginners
<zfp> 在 上传 | 大小:1.64mb | 下载:0

[软件工程DPSK

说明:本代码实现的是在实际情况下仿真DPSK调制信号在莱斯衰落信道下的各项性能分析-the code just for the DPSK signal of laisi
<Mike> 在 上传 | 大小:1kb | 下载:0

[matlab例程fuellekrug

说明:Extraction of real modes complex modes in the modal analysis associated with dynamics of structures-Extraction of real modes complex modes in the modal analysis associated with dynamics of structures
<Aryan Sarmadi> 在 上传 | 大小:1kb | 下载:0

[matlab例程WSN

说明:本文件用于演示无线传感器网络中的两个经典算法所编写的,关于无线传感器网络自身定位系统算法中的凸规划定位算法和DV-coordinate算法的演示。-This file is used to demonstrate wireless sensor networks written two classical algorithms, convex programming algorithm and DV-coordinate positioning algorithm demo on their o
<岳修文> 在 上传 | 大小:675kb | 下载:0

[matlab例程realtocomplex

说明:Extraction of real modes complex modes in the modal analysis associated to dynamics of structures-Extraction of real modes complex modes in the modal analysis associated to dynamics of structures
<Aryan Sarmadi> 在 上传 | 大小:1kb | 下载:0

[图形图像处理(光照,映射..)201405008

说明:matlab一维码识别 利用radon算子做水平方向矫正-radon correct
<liuhai> 在 上传 | 大小:221kb | 下载:0

[其他小程序fffffff

说明:如上图所示, Rst是低电平有效的系统复位信号,Clk是时钟信号。AB[5:0]是地址信号,DB[7:0]是数据信号,wr是低电平有效的写信号。start是启动信号。 模块中有一个64x8的双端口的存储器。系统复位结束后,可以通过AB、DB和wr信号向同步存储器写入数据。当写入64个数据后,给出一个Clk周期宽度的脉冲信号start,则系统从存储器0地址处开始读出数据,读出的8位数据从低位开始以3位为一组,每个时钟周期输出一组,即第一个时钟周期输出[2:0]位,第二个时钟周期输出[5:3]
<韩宇> 在 上传 | 大小:1kb | 下载:0

[matlab例程DialButtonsRecognition

说明:拨号按键识别GUI界面程序,原理采用DTMF,本程序随意按下六位数字,当按下第七位的时候屏幕清空,点击解析,结果将显示在文本框中,并有相应的声音。-GUI interface dial buttons identification procedures, principles using DTMF, this program free to press the six figures, when you press the seventh, when the screen is empty, c
<岳修文> 在 上传 | 大小:7kb | 下载:0

[通讯编程aspTest

说明:在网面模式下读卡IC卡的源码,在程序打开就可使用。-this a wee openm icka kdife,dfkdli,jiel
<guangyuan> 在 上传 | 大小:1kb | 下载:0

[数学计算/工程计算Character-Method

说明:管道一维非恒定流(水击)的特征线计算程序分享-Pipeline unsteady flow (water hammer) share the characteristic line calculation program
<王一平> 在 上传 | 大小:1kb | 下载:0

[Internet/网络编程tcp_sever

说明:主要是在基于liunx系统下用C语言编写文件的文件传输程序-Mainly under liunx system based on documents written in C language file transfer program
<宋大毛> 在 上传 | 大小:1kb | 下载:0
« 1 2 ... .02 .03 .04 .05 .06 215907.08 .09 .10 .11 .12 ... 267468 »

源码中国 www.ymcn.org