资源列表

« 1 2 ... .68 .69 .70 .71 .72 2173.74 .75 .76 .77 .78 ... 216384 »

[.net编程dotnet-programmes

说明:how to work with submit button -how to work with submit button ...
<chanti> 在 2025-07-04 上传 | 大小:1kb | 下载:0

[matlab例程mohukongwen

说明:基于模糊控制的PID温度控制器的设计 :将模糊控制和PID 控制相结合起来,通过模糊控制实现PID 参数自适应的方法来控制系统温度。这种Fuzzy- PID 策略,模糊控制的采用不是代替PID 控制,而是对传统控制方式的改进和扩展,它既保持了常规PID 控制系统结构简单、使用方便、鲁棒性强、控制精度高的优点,又采用模糊推理的方法实现了PID 参数PK、IK、DK的在线自整定,兼具了模糊控制灵活性、适应性强的特点,相比单纯的任一种控制效果都要好-PID temperature controller
<li> 在 2025-07-04 上传 | 大小:1kb | 下载:0

[VHDL编程spi_slave

说明:SPI功能模型,可以用于SPI的仿真验证工作,对其进行测试-Now for the SPI slave in the FPGA. Since the SPI bus is typically much slower than the FPGA operating clock speed, we choose to over-sample the SPI bus using the FPGA clock. That makes the slave code slightly more compli
<齐宇心> 在 2025-07-04 上传 | 大小:1kb | 下载:0

[其他行业spectrum

说明:建筑结构抗震中,用于计算指定地震波的反应谱,可计算位移谱,速度谱和加速度谱-in seismic design, used to calculate response spectrum
<zhouqiushang> 在 2025-07-04 上传 | 大小:1kb | 下载:0

[其他小程序dices

说明:掷筛子,随机生成两个数,显示为两个筛子的样子-rolling dices
<Nicolas> 在 2025-07-04 上传 | 大小:1kb | 下载:0

[压缩解压TEXT

说明:本设计利用STC89C51单片机的定时器/计数器定时和计数的原理,使其能精确计时。利用中断系统使其能实现开始暂停的功能。根据要求知道秒表设计主要实现的功能是计时和显示。因此设置了三个按键和LED显示时间,三个按键分别是开始、停止和复位按键。利用这三个建来实现秒表的全部功能,而LED则能显示最多59.99秒的计时。-This design uses STC89C51 microcontroller timer/counter timer counting principle and that it
<王崎权> 在 2025-07-04 上传 | 大小:1kb | 下载:0

[其他小程序anjian

说明:4×4键盘及8位数码管显示构成的电子密码锁-4 × 4 keyboard and eight digital display electronic locks constituted
<王崎权> 在 2025-07-04 上传 | 大小:1kb | 下载:0

[其他小程序wenduji

说明:利用AD590温度传感器完成温度的测量,把转换的温度值的模拟量送入ADC0809的其中一个通道进行A/D转换,将转换的结果进行温度值变换之后送入数码管显示。-After the completion of the use of AD590 temperature sensor to measure temperature, the temperature of the analog value to be converted into one of the channel ADC0809 for
<王崎权> 在 2025-07-04 上传 | 大小:1kb | 下载:0

[其他小程序guanggaodeng

说明:做单一灯的左移右移,硬件电路如图4.4.1所示,八个发光二极管L1-L8分别接在单片机的P1.0-P1.7接口上,输出“0”时,发光二极管亮,开始时P1.0→P1.1→P1.2→P1.3→┅→P1.7→P1.6→┅→P1.0亮,重复循环。-Single lamp left to do right, the hardware circuit shown in Figure 4.4.1, eight light-emitting diodes L1-L8 respectively connected
<王崎权> 在 2025-07-04 上传 | 大小:1kb | 下载:0

[其他小程序SVM_CV_estimate

说明:this file is svm estimator.
<zahra> 在 2025-07-04 上传 | 大小:1kb | 下载:0

[其他小程序jishuqi

说明:利用AT89S51单片机的T0、T1的定时计数器功能,来完成对输入的信号进行频率计数,计数的频率结果通过8位动态数码管显示出来。要求能够对0-250KHZ的信号频率进行准确计数,计数误差不超过±1HZ。-Use AT89S51 MCU T0, T1 timing counter function, to complete the input signal frequency counting, frequency counting results through eight dynamic di
<王崎权> 在 2025-07-04 上传 | 大小:1kb | 下载:0

[其他小程序svmPrediction

说明:this file is svm prediction.
<zahra> 在 2025-07-04 上传 | 大小:1kb | 下载:0
« 1 2 ... .68 .69 .70 .71 .72 2173.74 .75 .76 .77 .78 ... 216384 »

源码中国 www.ymcn.org