资源列表

« 1 2 ... .89 .90 .91 .92 .93 157594.95 .96 .97 .98 .99 ... 216391 »

[Internet/网络编程calendar

说明:ASP的calendar源码,仅供参考!-ASP source code of the calendar for reference purposes only!
<Ares_hao> 在 2025-10-21 上传 | 大小:9kb | 下载:0

[Internet/网络编程MakeCheckCode

说明:在网站的登录网页表单中生成需要填写中校验码-Sign in at the web pages generated in the form required to fill in the parity-check codes
<lianghuan> 在 2025-10-21 上传 | 大小:1kb | 下载:0

[并行运算C51programingfor93c46readandwrite

说明:在C51下编写的93C46的读写程序,实现读写操作-C51programing 93c46,read and write.
<fabine> 在 2025-10-21 上传 | 大小:4kb | 下载:0

[嵌入式/单片机编程FREQSYN

说明:使用Verilog语言编写的使用SPI总线设置频率LM2346,可通过设置其R寄存器对其输出频率进行设置(需相应的射频电路相配合)。-The use of Verilog language use SPI bus frequency settings LM2346, can be by setting up its R register set of its output frequency (to be matched by corresponding RF circuitry).
<张键> 在 2025-10-21 上传 | 大小:1kb | 下载:0

[串口编程uart

说明:uart协议、实现、验证,基于wishbone协议,工业标准为16550A-UART protocol, implementation, verification, based on the Wishbone protocol, the industry standard for the 16550A
<dannel218> 在 2025-10-21 上传 | 大小:251kb | 下载:0

[VHDL编程FPGA_FIFO

说明:使用Verilog编写的同步FIFO,可通过设置程序中的DEPTH设置FIFO的深度,FIFO_WRITE_CLOCK上升沿向FIFO中写入数据, FIFO_READ_CLOCK上升沿读取数据。本程序对FIFO上层操作简单实用。-Prepared by the use of Verilog synchronous FIFO, through the setup program in the FIFO depth DEPTH settings, FIFO_WRITE_CLOCK rising
<张键> 在 2025-10-21 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)main

说明:这是测量接触电阻的程序,我已定型生产,12位A/D,精度很高!-This is the contact resistance measurement procedure, I have stereotyped production, 12-bit A/D, high accuracy!
<周环东> 在 2025-10-21 上传 | 大小:95kb | 下载:0

[VHDL编程uart8

说明:使用Libero提供的异步通信IP核实现UART通信,并附带仿真程序。UART设置为1位开始位,8位数据位,1位停止位,无校验。且UART发送自带2级FIFO缓冲,占用FPGA面积很小。-Libero provided the use of asynchronous communication IP core implementation UART communications, and incidental simulation program. UART is set to 1 to sta
<张键> 在 2025-10-21 上传 | 大小:856kb | 下载:0

[图形图像处理(光照,映射..)mobileTracking

说明:运动物体跟踪,采用c,c++,opencv编写-mobile tracking
<lizhicheng> 在 2025-10-21 上传 | 大小:908kb | 下载:0

[嵌入式/单片机编程HEX

说明:专门为单片机初学者准备的两个小程序,我自己用来调试串行通讯的,一个是单片机不断的发送1234,一个是单片机的收发程序。-Singlechip beginners ready for the two procedures used to debug my own serial communications, a single-chip microcomputer are constantly sending 1234, a single-chip transceiver, the procedur
<王东平> 在 2025-10-21 上传 | 大小:2kb | 下载:0

[单片机(51,AVR,MSP430等)time

说明:这是我测试pcf8563的程序,可以试验时间芯片是否正常。-This is my test pcf8563 procedures, you can test whether it is normal for the time chip.
<周环东> 在 2025-10-21 上传 | 大小:17kb | 下载:0

[单片机(51,AVR,MSP430等)cunchu

说明:这是我测试存储芯片24C64的程序,可以存取数据。-This is my test memory chips 24C64 procedure, you can access the data.
<周环东> 在 2025-10-21 上传 | 大小:1kb | 下载:0
« 1 2 ... .89 .90 .91 .92 .93 157594.95 .96 .97 .98 .99 ... 216391 »

源码中国 www.ymcn.org