资源列表

« 1 2 ... .02 .03 .04 .05 .06 28007.08 .09 .10 .11 .12 ... 33928 »

[微处理器(ARM/PowerPC等)STM32F103-USART

说明:STM32F103 串口通信程序,适合初学者学习,可以直接应用。-STM32F103 serial communication programs, suitable for beginners to learn, can be applied directly.
<朱益民> 在 2025-06-03 上传 | 大小:1.29mb | 下载:0

[VHDL编程DDR2_VERILOG

说明:基于FPGA的DDR2_SDRAM的实现Verilog代码,比较实用,经过仿真验证。-Based on the FPGA implementation of DDR2_SDRAM Verilog code, more practical, proven by simulation.
<王虎> 在 2025-06-03 上传 | 大小:1.73mb | 下载:0

[嵌入式Linuxmipi_toshiba

说明:mipi_toshiba driver for arm linux
<Roman> 在 2025-06-03 上传 | 大小:8kb | 下载:0

[微处理器(ARM/PowerPC等)mipi_tc358764_dsi2lvds

说明:mipi_tc358764_dsi2lvds driver for arm linux
<Roman> 在 2025-06-03 上传 | 大小:8kb | 下载:0

[单片机(51,AVR,MSP430等)Code_Attitude

说明:参考MWC的四轴飞行器的代码,用的传感器是MPU6050和HMC5883.-Four aircraft MWC s reference code, using the sensor is MPU6050 and HMC5883.
<李龙翔> 在 2025-06-03 上传 | 大小:1.12mb | 下载:0

[单片机(51,AVR,MSP430等)JLINK-V8

说明:修复JLINK V8.0绿灯显示不亮状态和驱动程序丢失现象。按照本步骤即可修复JLINK V8.0-修复JLINK V8.0绿灯显示不亮状态和驱动程序丢失现象
<chouwj> 在 2025-06-03 上传 | 大小:10.13mb | 下载:0

[微处理器(ARM/PowerPC等)ARM-system-on-chip-Architecture

说明:The design of a general-purpose processor, in common with most engineering endeavours, requires the careful consideration of many trade-offs and compromises. In this chapter we will look at the basic principles of pr
<Henry Harrison> 在 2025-06-03 上传 | 大小:17.2mb | 下载:0

[单片机(51,AVR,MSP430等)S6D0165_LG2.8_MCU-8bit

说明:2.8 S6D0165 运用IC CODE-2.4 SSD1289
<mark> 在 2025-06-03 上传 | 大小:217kb | 下载:0

[嵌入式/单片机编程32LED-hex-

说明:32路LED控制 包括程序以及原理图,初学者必备材料!-32 LED control procedures including schematics Beginners essential material!
<王威> 在 2025-06-03 上传 | 大小:92kb | 下载:0

[微处理器(ARM/PowerPC等)Co-verification-of-Hardware-and-Software-for-ARM-

说明:Co-verification of Hardware and Software for ARM SoC Design This book is the first to document and teach important information about the verification technique known as hardware/software co-verification. Tradition
<Henry Harrison> 在 2025-06-03 上传 | 大小:1.77mb | 下载:0

[单片机(51,AVR,MSP430等)430

说明:430单片机实现电子秤的程序,其实就是采集模拟信号,硬件部分是小信号的放大。-my English is poor
<尚磊> 在 2025-06-03 上传 | 大小:172kb | 下载:0

[DSP编程T-speed

说明:利用CCS编写的DSP工程,代码主要实现的功能就是对一段位移进行T型速度规划,在板子上跑拥有很不错的速度和位移响应曲线-Use of CCS projects written in DSP code main function is to carry out some T-displacement velocity planning on running board has very good velocity and displace
<linfengli> 在 2025-06-03 上传 | 大小:573kb | 下载:0
« 1 2 ... .02 .03 .04 .05 .06 28007.08 .09 .10 .11 .12 ... 33928 »

源码中国 www.ymcn.org