资源列表

« 1 2 ... .21 .22 .23 .24 .25 28526.27 .28 .29 .30 .31 ... 33928 »

[单片机(51,AVR,MSP430等)SPK

说明:通过 调节循环中的延时量,改变蜂鸣器的频率,效果是影片里可以听到的定时弹快要爆炸时定时器发出的声音-By adjusting the delay through the cycle of change, the buzzer frequency, the effect is timing bomb in the film is about to explode when the timer can be heard the sound of
<扬帆> 在 2025-07-27 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)24C02

说明:对I2C 2402的00地址写a5,后读出显示到P1的LED上 8个灯接p1口,led的公共极为p0.1 -Write A5 address of 00 I2C 2402, read after to the P1 display LED 8 lamp is connected with the P1 port, led public extremely p0.1
<扬帆> 在 2025-07-27 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)motor

说明:本程序用于测试4相步进电机常规驱动 使用1-2相励磁 1-2相激励功率增倍,步进角度减半,抖动减少 顺序如下 a-ab-b-bc-c-cd-d-da 又称4相8拍-1-2 phase excitation power double stepping angle halved, jitter reduction The following sequence of a-ab-b-bc-c-cd-d-da is also called the 4 phase 8 beat
<扬帆> 在 2025-07-27 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)PWM

说明:通过PWM(脉宽调制)调节LED的亮度 定义 LED到P1.0端口 改变led循环中的延时量实现调光-Through the PWM (pulse width modulation) adjust the brightness of LED definition LED to P1.0 port change amount of delay in the LED loop to achieve dimming
<扬帆> 在 2025-07-27 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)JDQ

说明:P1.4引脚控制三极管再由三极管控制继电器 输出1三极管导通继电器得电吸合,输出0三极管截止继电器失电断开-The P1.4 pin control triode again by the triode control relay output 1 triode relay is attracted, the output of the 0 transistor cut-off relay power loss off
<扬帆> 在 2025-07-27 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)C1101__test51

说明:51单片机433无线模块 时钟信号同步显示-51 microcontroller 433 wireless module test
<郭亮> 在 2025-07-27 上传 | 大小:105kb | 下载:0

[单片机(51,AVR,MSP430等)key

说明:stm32f103的矩阵键盘扫描程序,使用线反转法进行扫描。-scanning stm32f103 matrix keyboard scanner, using the line reversal method
<孙过强> 在 2025-07-27 上传 | 大小:2kb | 下载:0

[VHDL编程PS2_keyboard_interrupt-A

说明:实现fpga读取PS2键盘的功能,内有完整的仿真文件-Implementation of FPGA read PS2 keyboard function, there are simulation file integrity of the
<赵振超> 在 2025-07-27 上传 | 大小:501kb | 下载:0

[VHDL编程sixuanyi

说明:该程序主要是用VHDL编程来实现四选一的电路设计,并可在此基础上修改。-This program is mainly used VHDL programming to achieve one of four selected circuit design, and can be modified on this basis.
<谭莉> 在 2025-07-27 上传 | 大小:3kb | 下载:0

[DSP编程DM642_flash_v3.3

说明:TI DM642 外扩flash 读写程序-TI DM642 flash write and read
<文毅> 在 2025-07-27 上传 | 大小:683kb | 下载:0

[DSP编程DM642_loop2_v3.3

说明:TI DM642 DSP 视频编解码 视频图像帧处理-TI DM642 DSP video codec video fr a me processing
<文毅> 在 2025-07-27 上传 | 大小:704kb | 下载:0

[VHDL编程Dchufaqi

说明:用VHDL语言编程来实现D触发器以及它的各个功能。-VHDL language programming to achieve D flip-flop and its various functions.
<谭莉> 在 2025-07-27 上传 | 大小:3kb | 下载:0
« 1 2 ... .21 .22 .23 .24 .25 28526.27 .28 .29 .30 .31 ... 33928 »

源码中国 www.ymcn.org