资源列表

« 1 2 ... .93 .94 .95 .96 .97 23498.99 .00 .01 .02 .03 ... 33928 »

[VHDL编程signal

说明:verilog写得一个信号源,很爽的,输出667hz信号超级准-verilog write a signal source, so cool, and the output signal is super-quasi-667hz
<lanmse> 在 2025-07-18 上传 | 大小:309kb | 下载:0

[VHDL编程nios_sram_gm

说明:小模式下配置的nios源码,用quartus10.0配置,作者光芒电子-Nios small mode configuration source, with quartus10.0 configuration of the electronic light
<lanmse> 在 2025-07-18 上传 | 大小:8.76mb | 下载:0

[单片机(51,AVR,MSP430等)Add

说明:Add function - adding to number example
<rakeshls> 在 2025-07-18 上传 | 大小:22kb | 下载:0

[单片机(51,AVR,MSP430等)c8051f360

说明:51c360配置文件,用于89C51单片机的-51c360 profile
<lucen> 在 2025-07-18 上传 | 大小:4kb | 下载:0

[单片机(51,AVR,MSP430等)diskio

说明:单片机SD卡读写操作底层驱动程序,8051Cxx系列可用到-SCM SD card read and write low-level driver
<lucen> 在 2025-07-18 上传 | 大小:3kb | 下载:0

[单片机(51,AVR,MSP430等)max7219

说明:使用51单片机控制max7219芯片驱动8位数码管。-Use 51 single-chip microcomputer control max7219 chip drive 8-bit digital tube.
<老王> 在 2025-07-18 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)ADC

说明:LPc1768单片机的adc使用例程,具有很好的参考价值-LPc1768 microcontroller adc using routine, with a good reference value
<电子迷> 在 2025-07-18 上传 | 大小:234kb | 下载:0

[单片机(51,AVR,MSP430等)Blinky

说明:LPc1768单片机的流水灯使用例程,具有很好的参考价值-LPc1768 single chip using routine light water, a good reference value
<电子迷> 在 2025-07-18 上传 | 大小:18kb | 下载:0

[VxWorksLCD

说明:s3c2440 LCD vxWorks环境下驱动程序-s3c2440 vxworks lcd driver
<陈超杰> 在 2025-07-18 上传 | 大小:11kb | 下载:0

[单片机(51,AVR,MSP430等)feibiao

说明:利用keil软件写的C语言控制51单片机做了一个点灯程序(飞镖),内有protues的仿真文件。-Using keil software write c-language control 51 SCM made a light program (darts), there are protues simulation files.
<老王> 在 2025-07-18 上传 | 大小:27kb | 下载:0

[单片机(51,AVR,MSP430等)ADC_test

说明:本实验实现对ADC的测试,并通过串口输出相关信息。 本程序运行方式为将程序下载到Internal Flash中运行。-ADC to achieve this study test, and information output through the serial port. Run this program as the program to the Internal Flash to run.
<李嘉> 在 2025-07-18 上传 | 大小:62kb | 下载:0

[嵌入式/单片机编程DMA_Test

说明:DMA测试例程,使用DMA的link list模式进行数据的传输。程序中把源缓冲区SRC1_Buffer和源 缓冲区SRC2_Buffer里面的数据,通过DMA的link list模式分别传输到目标缓冲区DST1_Buffer和 目标缓冲区DST2_Buffer。相应信息可在串口显示。-DMA test routines, the link list using the DMA data transfer mode. Program and the source of the sourc
<李嘉> 在 2025-07-18 上传 | 大小:87kb | 下载:0
« 1 2 ... .93 .94 .95 .96 .97 23498.99 .00 .01 .02 .03 ... 33928 »

源码中国 www.ymcn.org