资源列表
[单片机(51,AVR,MSP430等)] generation-of-square-waveforms-
说明:本程序能够在51单片机上实现方波产生,并且相位可调和频率可调的功能。-This program can realize the generation of square waveform on MCU of 51 series.And the phase and frequency of the square waveform can be adjusted<杨涛> 在 2025-06-17 上传 | 大小:4kb | 下载:0
[单片机(51,AVR,MSP430等)] simulation-phase-adjusted
说明:本文件可在proteus中实现两路相位和频率可调的方波仿真实现,并可以在51单片机上实现-This file can realize the simulation of generation of two ways square waveforms of which phase and frequency can be adjusted under the platform of the Proteus.And it can be operated on the MCU of 51 series<杨涛> 在 2025-06-17 上传 | 大小:20kb | 下载:0
[VHDL编程] VHDL_ReversibleCounter
说明:可逆计数器(两位十六进制,以十进制方式显示即从00,01数到14,15然后00,01再到根据10hz晶振(低频都可选,视板子情况而定)作为时间脉冲计数,rst键可以重置(清零 )计数器,drct键选择加法计数还是减法计数.-2-bit-Hexadecimal Reversible Counter(decimal display)<杨联开> 在 2025-06-17 上传 | 大小:1kb | 下载:0
[其他嵌入式/单片机内容] L3G4200D__51
说明:基于51单片机的L3G4200D的IIC测试代码-Based on 51 single-chip L3G4200D the IIC test code<fda> 在 2025-06-17 上传 | 大小:13kb | 下载:0
[单片机(51,AVR,MSP430等)] OLED
说明:stm8菜鸟纯移植51oled,模拟IIC,希望对初学者有个参考-stm8 rookie pure transplantation 51oled, simulation IIC,<姚志健> 在 2025-06-17 上传 | 大小:73kb | 下载:0
[单片机(51,AVR,MSP430等)] Project_3
说明:飞思卡尔,用双舵机的好处就是不会跑丢黑线,通过计算摆头舵机的偏差,来控制转向舵机。 基本思路就是这样,当然具体程序还要考虑很多东西。 -Freescale, the benefits of using dual servos just will not get lost black line, by calculating the deviation swing servos to control the steering servo. The basic idea is<姚志健> 在 2025-06-17 上传 | 大小:294kb | 下载:0
[DSP编程] Advanced-DSP-and-noise-reduction
说明:高级数字信号处理与降噪!原理性文档,不适用.不要错过-Advanced digital signal processing and noise reduction<杨林> 在 2025-06-17 上传 | 大小:3.59mb | 下载:0
[其他嵌入式/单片机内容] lcd_dispaly-eeprom
说明:8051 EEPROM and LCD display<jiashing sheu> 在 2025-06-17 上传 | 大小:49kb | 下载:0
[VHDL编程] Alarm_Microblaze_ASM
说明:A Alarm system writed in Assembly to use on a Microblaze VHDL project.<Gabriel> 在 2025-06-17 上传 | 大小:273kb | 下载:0
[嵌入式Linux] Mini2440_GPIOPLCD-44780
说明:A kernel level driver for a character display LCD-44780, to use with the kit FriendlyArm Mini2440. This zip contains the howto create the board to connect to the kit GPIOs and howto compile and flash to the kernel.<Gabriel> 在 2025-06-17 上传 | 大小:524kb | 下载:0
[单片机(51,AVR,MSP430等)] code-sig_generate-V1.2
说明:基于fpga的DDS的单片机控制端。设置波形选择,频率,幅度设置按键。幅度控制主要用到VCA810。-DDS fpga-based microcontroller control side. Set waveform selection, frequency, amplitude settings button. Amplitude control is mainly used VCA810.<王志瑞> 在 2025-06-17 上传 | 大小:50kb | 下载:0