资源列表
[嵌入式/单片机编程] lcd_template
说明:嵌入式编程-ARM-PXA270-LCD 已确定C环境,LCD驱动2份。5百KB,RAR已经很好压缩。-Embedded programming-ARM-PXA270-LCD has identified C environment, LCD driver 2 copies. 5 hundred KB, RAR has been very good compression.<john> 在 2025-06-21 上传 | 大小:575kb | 下载:0
[微处理器(ARM/PowerPC等)] TouchScreen
说明:嵌入式编程-ARM-PXA270-EELiod 基础实验-触摸屏 触摸屏驱动程序,C运行环境已确定。-Embedded programming-ARM-PXA270-EELiod basic experiment- the touch screen touch screen driver, C runtime environment have been identified.<john> 在 2025-06-21 上传 | 大小:589kb | 下载:0
[单片机(51,AVR,MSP430等)] TEST44X_E2prom
说明:基于MSP430的IIC总线功能 读写EEPROM的程序 已经验证成功-MSP430-based read and write EEPROM IIC bus functional verification procedures have been successfully<河南> 在 2025-06-21 上传 | 大小:1kb | 下载:0
[VHDL编程] chipscope_pro_siotk_10_1_ug213
说明:XILINX赛灵斯chipscope_pro_siotk_10_1_ug213使用手册,讲得挺详细的。-the introduction of XILINX chipscope<张扬> 在 2025-06-21 上传 | 大小:766kb | 下载:0
[单片机(51,AVR,MSP430等)] 666point
说明:通过232口用命令控制六路开关,分别输出控制信号-Control by 232 six-way switch with the command<lcx> 在 2025-06-21 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] pluse
说明:通过遥控模块接收命令控制电机的动作和运动方向,全速运行一段后转入减速运行。-Receive commands through the remote control module to control the motor direction of movement and motion, full-speed into the deceleration after running for a while.<lcx> 在 2025-06-21 上传 | 大小:3kb | 下载:0
[嵌入式/单片机编程] TIMER_test_GEC2410
说明:TIMER_test_GEC2410 是广嵌开发板上做的定时器、PWM 输出实验-TIMER_test_GEC2410 is widely embedded development board to do the timer, PWM output experiment<冯健琥> 在 2025-06-21 上传 | 大小:21kb | 下载:0
[嵌入式/单片机编程] guiRTC_test_GEC2410
说明:guiRTC_test_GEC2410 是在广嵌GEC2410板上做的RTC实验-guiRTC_test_GEC2410 widely embedded in the board to do the RTC experiment GEC2410<冯健琥> 在 2025-06-21 上传 | 大小:41kb | 下载:0