资源列表

« 1 2 ... .65 .66 .67 .68 .69 27670.71 .72 .73 .74 .75 ... 33928 »

[嵌入式/单片机编程xinhaodeng

说明:不错的交通灯控制程序。实现十字路*通灯功能,有过街中断按钮和紧急过街按钮-Good traffic lights control procedures. Realize the crossroads traffic lights function, the street has interrupted the street button and emergency button
<环境光> 在 2025-09-22 上传 | 大小:1kb | 下载:0

[嵌入式/单片机编程xjxc

说明:智能的循迹小车程序,比一般的循迹小车的反应灵敏度快的多。-The intelligent tracking car program, sensitivity than the reaction of the general tracking car faster.
<ceindex> 在 2025-09-22 上传 | 大小:1kb | 下载:0

[嵌入式/单片机编程xmodem

说明:基于S3C2440的xmodem协议,主要是移植vivi里面的xmodem-The xmodem protocol based S3C2440, mainly inside the xmodem transplant vivi
<rkingt> 在 2025-09-22 上传 | 大小:3kb | 下载:0

[嵌入式/单片机编程xram_interface

说明:经过验证的,并且能够成功流片的设计中51core一个关键子模块!可以直接重用! -Proven and successful design of silicon 51core a key sub-module! Can reuse!
<sedto> 在 2025-09-22 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)huibianban

说明:按键控制LED灯的汇编程序,可实现按键控制LED灯的亮灭,主要是用汇编语言写的可以学习汇编-Button control keys to control LED lights LED lights LED light button control keys to control LED lights
<hanhui> 在 2025-09-22 上传 | 大小:5kb | 下载:0

[单片机(51,AVR,MSP430等)The-room-call-system

说明:一款基于STC10F08XE单片机的房间呼叫系统。-A STC10F08XE single chip computer room based on call system.
<肖生全> 在 2025-09-22 上传 | 大小:129kb | 下载:0

[嵌入式/单片机编程xsp

说明:这是一张PROTEL图,是显示盘的电路原理图,大家可以参考一下,学习如何使用原理图-This is a PROTEL map is to show the circuit schematic diagram disk, we can refer to, learning how to use the schematic diagram
<监控键盘> 在 2025-09-22 上传 | 大小:2kb | 下载:0

[嵌入式/单片机编程xuexiyong

说明:在网上搜得的电子元件资料,分享和大家共同学习!-Was found in the online electronic component information, sharing and common learning!
<ebythe> 在 2025-09-22 上传 | 大小:6kb | 下载:0

[嵌入式/单片机编程xuliejianceqi

说明:检测一个5位的二进制序列“10101”(可重复检测),当连续的5个输入为10101时输出为1,其他情况下输入为0。-Detection of a 5-bit binary sequence " 10101" (repeatable test), when successive five input 10101 when the output is 1, otherwise enter 0.
<hatwa> 在 2025-09-22 上传 | 大小:1kb | 下载:0

[嵌入式/单片机编程xunji

说明:循迹小车源程序,刚做好的,芯片是at89cs51-免费提供
<dropins> 在 2025-09-22 上传 | 大小:1kb | 下载:0

[嵌入式/单片机编程xunjixiaoshe

说明:循迹小车控制程序,懂程序的一看就明白,硬件用51系列单片机,直流电机驱动芯片,发光二极管,光敏电阻和比较器。-Car tracking control procedures, understand the program see at the hardware using 51 series, DC motor driver chips, light emitting diodes, photosensitive resistors and comparators.
<王小京> 在 2025-09-22 上传 | 大小:4kb | 下载:0

[微处理器(ARM/PowerPC等)software-uart-

说明:software UART for embedded system with C compiler , comment are in the file for analysis code
<MOHAMAD REZA> 在 2025-09-22 上传 | 大小:1kb | 下载:0
« 1 2 ... .65 .66 .67 .68 .69 27670.71 .72 .73 .74 .75 ... 33928 »

源码中国 www.ymcn.org