资源列表
[VHDL编程] TIs-HDMIDVI-to-LVDS-Bridge-solutions
说明:This a brief introduction of TI s HDMI/DVI to LVDS Bridge solutions and an component selection guide. It is good reference for mobilephone or tablet PC system developers who need to develop LCD interface. This document provides an overview of H<jazzclassics> 在 2025-07-21 上传 | 大小:100kb | 下载:0
[DSP编程] AD7865
说明:The AD7865 is a fast, low power, four-channel simultaneous sampling 14-bit A/D converter that operates from a single 5 V supply. The part contains a 2.4 μs successive approximation ADC, four track/hold amplifiers, 2.5 V reference, on-chip clock<srinivas> 在 2025-07-21 上传 | 大小:189kb | 下载:0
[DSP编程] 7.2-video_loopback
说明:TI TMS320DM6437 视频回放的一个例子。 -An example of TI TMS320DM6437 video playback.<薛成武> 在 2025-07-21 上传 | 大小:118kb | 下载:0
[单片机(51,AVR,MSP430等)] NewWater
说明:这是C语言编写的煤矿用自动加水程序,开发环境是KEIL,此代码通过调试,里面有很多技巧。对于用C语言开发嵌入式系统有重要参考价值。 -It is written in C language for use in mines automatic water program, the development environment is KEIL, this code by debugging, there are a lot of skills. For embedded systems us<戴建华> 在 2025-07-21 上传 | 大小:8kb | 下载:0
[微处理器(ARM/PowerPC等)] am5k2e04
说明:The AM5K2E04/02 is a high performance device based on TI s KeyStone II Multicore SoC Architecture, incorporating the most performance-optimized Cortex-A15 processor dual-core or quad-core CorePac that can run at a core speed of up to 1.4 GHz. TI<srinivas> 在 2025-07-21 上传 | 大小:1.99mb | 下载:0
[单片机(51,AVR,MSP430等)] zdp
说明:Thyristor Surge Thyristor Surge -Thyristor SurgeThyristor SurgeThyristor SurgeThyristor Surge<man he> 在 2025-07-21 上传 | 大小:3kb | 下载:0
[单片机(51,AVR,MSP430等)] SIN_SPWM
说明:利用SPWM调制产生正弦信号,可运用与各种电子器件的测量,如电压、电容、电阻等。-SPWM modulation using sinusoidal signal can be measured with the use of various electronic devices, such as voltage, capacitance, resistance and the like.<孟林> 在 2025-07-21 上传 | 大小:274kb | 下载:0
[单片机(51,AVR,MSP430等)] ADC0_Buf1
说明:此程序为使用ADC0的例程 在中断模式使用定时器3溢出作为开始启动信号并采样AIN0<NUM_SAMPLES>次将结果存储在XDATA空间 一旦<NUM_SAMPLES>次被采集 采样值从UART0传输 一旦传输结束 另一个数据采样次数<NUM_SAMPLES>将被采集并重复此处理过程.-This procedure for routine use ADC0 interrupt mode using the timer 3 overflow started a<sam> 在 2025-07-21 上传 | 大小:3kb | 下载:0
[单片机(51,AVR,MSP430等)] ADC0_Poll1
说明:此例程说明了 ADC0在查询模式的操作 ADC0设置为写AD0BUSY作为其转换开始信号 并测量片内温度传感器的输出温度传感器的输出转换成摄氏度并从UART0传输。-This routine illustrates the ADC0 ADC0 set the query mode in operation for write AD0BUSY as its conversion start signal and measuring the on-chip temperature sensor<kobe> 在 2025-07-21 上传 | 大小:2kb | 下载:0
[单片机(51,AVR,MSP430等)] OSC_Cry1
说明:此例程说明如何配置外部振荡器驱动22.1184Mhz晶体及如何选择此外部振荡器作为系统时钟 同时使能丢失时钟检测器复位功能。 假定22.1184Mhz晶体连接在XTAL1和XTAL2之间-This routine shows how to configure an external crystal oscillator drive 22.1184Mhz and how to this external oscillator as the system clock while Enable<kobe> 在 2025-07-21 上传 | 大小:1kb | 下载:0
[其他嵌入式/单片机内容] LwIP-MQTT-Client--Example
说明:LWIP MQTT Client Example Source<ANDREW> 在 2025-07-21 上传 | 大小:5kb | 下载:0