[VHDL编程] 05-NEC_2003_D

说明：简易逻辑分析仪（2003年D题），verilog源程序-Simple logic analyzer (, 2003 D), Verilog source code
<艾米丽> 在 2025-06-30 上传 | 大小：408kb | 下载：0

[VHDL编程] 06-NEC_2005_A

说明：06-正弦信号发生器（2005年A题），verilog源程序-06- sinusoidal signal generator (2005 A question), Verilog source code
<艾米丽> 在 2025-06-30 上传 | 大小：707kb | 下载：0

[单片机(51,AVR,MSP430等)] 00189R1_Firmware_2

说明：code for Can bus using ccs
<van> 在 2025-06-30 上传 | 大小：660kb | 下载：0

[单片机(51,AVR,MSP430等)] Lab_BP

说明：Indicator for laboratories power suplier in avr microcontroller
<Vjacheslav> 在 2025-06-30 上传 | 大小：1kb | 下载：0

[单片机(51,AVR,MSP430等)] JTD

说明：通过并行接口8255实现十字路*通灯的模拟控制，掌握对并行口的使用。-Through the parallel interface 8255, the analog control of the crossroads traffic lights, to master the use of the parallel port.
<雅格> 在 2025-06-30 上传 | 大小：1kb | 下载：0

[单片机(51,AVR,MSP430等)] lcdbl

说明：液晶背光控制实验通过8253计数器显示一个122*32点阵图形-Display a 122 x 32 dot graphic LCD backlight control experiment by the 8253 counter
<雅格> 在 2025-06-30 上传 | 大小：2kb | 下载：0

[VHDL编程] alarm

说明：The red arrow showed the output became 8 when the measured temperature changed to 11°C. As shown by black arrow, the maximum output was 28. The program was run according to the proposed method.
<jayjay> 在 2025-06-30 上传 | 大小：99kb | 下载：0

[VHDL编程] comp

说明：The red arrow showed the output became 8 when the measured temperature changed to 11°C. As shown by black arrow, the maximum output was 28. The program was run according to the proposed method.
<jayjay> 在 2025-06-30 上传 | 大小：112kb | 下载：0

[VHDL编程] 8.3-LCD

说明：FPGA驱动LCD显示中文字符程序及状态机的使用-FPGA to drive the LCD display Chinese characters procedures and the use of the state machine
<林高办> 在 2025-06-30 上传 | 大小：5kb | 下载：0

[VHDL编程] curtain

说明：The red arrow showed the output became 8 when the measured temperature changed to 11°C. As shown by black arrow, the maximum output was 28. The program was run according to the proposed method.
<jayjay> 在 2025-06-30 上传 | 大小：112kb | 下载：0

[VHDL编程] lighting

说明：The red arrow showed the output became 8 when the measured temperature changed to 11°C. As shown by black arrow, the maximum output was 28. The program was run according to the proposed method.
<jayjay> 在 2025-06-30 上传 | 大小：89kb | 下载：0

[VHDL编程] modulated_gen

说明：The red arrow showed the output became 8 when the measured temperature changed to 11°C. As shown by black arrow, the maximum output was 28. The program was run according to the proposed method.
<jayjay> 在 2025-06-30 上传 | 大小：183kb | 下载：0