资源列表

« 1 2 ... .67 .68 .69 .70 .71 22472.73 .74 .75 .76 .77 ... 33928 »

[uCOS开发UCOS_II

说明:UCos-II核代码及系统移植后的程序,在S3C440上运行.-UCos-II nuclear code and system after the transplant procedure, S3C440 run.
<> 在 2025-11-22 上传 | 大小:21kb | 下载:0

[单片机(51,AVR,MSP430等)mea_freq

说明:以51单片机为处理器,测量方波信号的频率-51 singlechip processor, measuring the frequency of square wave signals
<lwf> 在 2025-11-22 上传 | 大小:21kb | 下载:0

[单片机(51,AVR,MSP430等)msp430-dma

说明:MSP430单片机DMA例子程序,是学习MSP430单片机的最好参考-Single-chip DMA example MSP430 procedures, is to learn from the best reference MSP430 MCU
<rolston> 在 2025-11-22 上传 | 大小:21kb | 下载:0

[嵌入式Linuxuart

说明:实现在44B0开发板实现串口输入输出功能。 开发环境:ADS1.2-Development board in the 44B0 realize realize serial input and output functions. Development Environment: ADS1.2
<况海斌> 在 2025-11-22 上传 | 大小:21kb | 下载:0

[单片机(51,AVR,MSP430等)CE034_CAN_Loopback_091207

说明:pic单片机PIC30系列C语言编程资料。。。。。加油下啊。-pic Singlechip PIC30 Series C language programming information. . . . . Refueling under ah.
<> 在 2025-11-22 上传 | 大小:21kb | 下载:0

[单片机(51,AVR,MSP430等)ds18b20

说明:3、《ds1302a》实验 说明:本程序通过串口通信(借助串口调试等程序),让单片机读写DS1302,结果返回到PC的串口调试接收区。 1)下载程序 2)打开串口调试助手 3)通过串口调试助手向ELITE-III发送"5501aa"(注:十六进制,55为设定的字串头,01为设定的1302命令,aa为设定的结束字串尾。)启动DS1302工作,成功则返回55,失败则返回00 4)通过串口调试助手向ELITE-III发送"5502aa"(注:十六进制,55为设定的字串头,02为读取1302命令,aa为
<段威吉> 在 2025-11-22 上传 | 大小:21kb | 下载:0

[嵌入式Linuxbeep-sound-S3C44B0

说明:ADS1.2软件下测试,是蜂鸣器的相关程序,在S3C44B0开发板下可以让蜂鸣器工作。-ADS1.2 software under test, is the buzzer of the associated procedures, in S3C44B0 under development board allows the work buzzer.
<ylwt01> 在 2025-11-22 上传 | 大小:21kb | 下载:0

[单片机(51,AVR,MSP430等)CE122_ADC_AltSamp_091207

说明:Alter among different sample channels when using A/D for dspic programming.
<ecc29> 在 2025-11-22 上传 | 大小:21kb | 下载:0

[嵌入式/单片机编程EP1C6_12_3_VGAimg

说明:基于fpga和sopc的用VHDL语言编写的EDA的VGA彩条信号显示控制器-FPGA and SOPC based on the use of VHDL language EDA color signal of the VGA display controller
<多幅撒> 在 2025-11-22 上传 | 大小:21kb | 下载:0

[嵌入式Linuxsct

说明:做嵌入式的串口设置时,可以直接把sct解压了,然后直接make。 测试串口是否可以工作正常,很好的代码。-So embedded serial port settings, you can extract directly to the sct and then directly make. Test serial port can work in normal, good code.
<billwfox> 在 2025-11-22 上传 | 大小:21kb | 下载:0

[其他嵌入式/单片机内容XXSD_Card

说明:51的SD卡驱动程序库,做此项目的朋友可以参考一下 -51 of the SD card driver library, so this project can refer to a friend
<> 在 2025-11-22 上传 | 大小:21kb | 下载:0

[其他嵌入式/单片机内容123

说明:信号的采样与保持-Signal Sampling and maintain
<> 在 2025-11-22 上传 | 大小:21kb | 下载:0
« 1 2 ... .67 .68 .69 .70 .71 22472.73 .74 .75 .76 .77 ... 33928 »

源码中国 www.ymcn.org