资源列表

« 1 2 ... .03 .04 .05 .06 .07 28708.09 .10 .11 .12 .13 ... 33928 »

[单片机(51,AVR,MSP430等)512

说明:学生设计的音乐盒,只用一首歌,供学生参考实用-Music box designed by the students, with only a song, and practical for students' reference
<TZ> 在 2026-01-14 上传 | 大小:3kb | 下载:0

[其他嵌入式/单片机内容Pronunciation-keys

说明:按下不同的按键会是 SOUNDER 发出不同频率的声音。本例使用延时函数实现不同频率的声音 输出,以后也可使用定时器 -Press a different key is the SOUNDER issued different frequencies of sound. This example uses the sound output of the delay function of different frequencies, can also be used later timer
<李翠> 在 2026-01-14 上传 | 大小:3kb | 下载:0

[单片机(51,AVR,MSP430等)I2C_Drive

说明:i2c驱动(另类的哦)主要是基本的东西。还有的自己看了就知道啦-Offbeat I2C driver
<小钟> 在 2026-01-14 上传 | 大小:3kb | 下载:0

[单片机(51,AVR,MSP430等)MCUButtonAlarm

说明:我的单片机课程设计代码,用于汇编语言编写的单片机代码,实现按键设定报警值,当AD采集值大于设定值实现报警功能,总共可设定四组值。-My MCU Design code for microcontroller code written in assembly language, the buttons to set the alarm value the AD acquisition value is greater than the set value alarm function can be
<吴雨> 在 2026-01-14 上传 | 大小:3kb | 下载:0

[单片机(51,AVR,MSP430等)MCU_PID_motor_control

说明:用C语言编写的单片机直流电机控制课程设计代码,控制算法采用比较基本的PID算法,转速测量使用编码器实现。-Microcontroller C language DC motor control curriculum design code, the control algorithm uses the basic PID algorithm speed measurement encoder.
<吴雨> 在 2026-01-14 上传 | 大小:3kb | 下载:0

[微处理器(ARM/PowerPC等)yangche

说明:这个是第八届飞思卡尔智能车比赛的电磁组的程序,用的是3个电感。-This is a the electromagnetic group of eighth Freescale smart car competition program, three inductor.
<bill> 在 2026-01-14 上传 | 大小:3kb | 下载:0

[VHDL编程chenxu

说明: 利用状态机设计正弦波信号发生器: //输出4位接4位的DA转换,即4位数字信号输出可直接通过DA转换为模拟信号。 -The use of state machine design is the sine wave signal generator:// output 4 connects a 4-bit DA converter, i.e. the 4-bit digital signal output can be directly through the DA converte
<hehe> 在 2026-01-14 上传 | 大小:3kb | 下载:0

[VHDL编程chengxu

说明:设计状态机从SRAM中读取数据,并相加,即求SRAM【7:0】【2:0】中8个字节数的和并输出,SRAM为内置RAM-Design state machine to read data from the SRAM, and added, that is seeking SRAM [7:0] [2:0] 8 bytes and output, SRAM built-in RAM
<hehe> 在 2026-01-14 上传 | 大小:3kb | 下载:0

[VHDL编程chengxu

说明:读取外部RAM的状态机 RAM接口OE,输出使能 WR,低电平写RAM AB【7:0】地址总线 DB【7:0】地址总线 //将RAM 0至127的数据读出并相加最后的结果存入地址254(低8位)255(高8位) -State machine reads the external RAM RAM interface OE Output Enable WR, low-level to write RAM AB [7:0] address bus DB [7:0
<hehe> 在 2026-01-14 上传 | 大小:3kb | 下载:0

[VHDL编程one

说明:做数字频率计所需要的系数为6.5的分频器相关编程作为参考-Need to do the digital frequency meter factor of 6.5 as a reference divider programming
<汪璇> 在 2026-01-14 上传 | 大小:3kb | 下载:0

[DSP编程Test_FPU_CFFTF32

说明:TI C2833X系列dsp 官方浮点cfft程序-TI C2833X series dsp official floating-point cfft of program
<> 在 2026-01-14 上传 | 大小:3kb | 下载:0

[单片机(51,AVR,MSP430等)Balance_Kalman

说明:平衡算法,基于卡尔曼的滤波和avr单片机来实现自平衡小车的主要算法-Balancing algorithm to achieve self-balancing car algorithm based on Kalman filtering and AVR microcontroller
<张辉> 在 2026-01-14 上传 | 大小:3kb | 下载:0
« 1 2 ... .03 .04 .05 .06 .07 28708.09 .10 .11 .12 .13 ... 33928 »

源码中国 www.ymcn.org