资源列表

« 1 2 ... .72 .73 .74 .75 .76 30377.78 .79 .80 .81 .82 ... 33928 »

[单片机(51,AVR,MSP430等)cyz

说明:利用keil软件采用循环结构实现8个lcd灯轮流闪烁-Use keil software using cyclic structure to achieve 8 lcd lights flashing alternately
<周杨> 在 2026-01-15 上传 | 大小:2kb | 下载:0

[VHDL编程LCD

说明:点亮spartan—3e上的LCD模块 成功显示OK!-Lit spartan-3e success on the LCD module display OK!
<> 在 2026-01-15 上传 | 大小:2kb | 下载:0

[单片机(51,AVR,MSP430等)dianzizhong

说明:基于89c52单片机的电子琴设计,硬件课通过程序看出-89c52 microcontroller based keyboard design, hardware courses through the program to see
<绿山> 在 2026-01-15 上传 | 大小:2kb | 下载:0

[单片机(51,AVR,MSP430等)iic_pcf8563

说明:PCF8563在PIC16LF1947上的非模拟IIC读写时钟程序-PCF8563 in PIC16LF1947 IIC reading on the non-simulated clock program
<姚之满> 在 2026-01-15 上传 | 大小:2kb | 下载:0

[单片机(51,AVR,MSP430等)SHTXX

说明:SHT75温湿度传感器ATmega8驱动,运行过的-SHT75 temperature and humidity sensor ATmega8-driven, run-off
<工程师 > 在 2026-01-15 上传 | 大小:2kb | 下载:0

[嵌入式Linuxa

说明:用于linux下,支持jpg格式的usb摄像头一帧图像获取,并保存为jpg格式文件-For linux, support jpg format usb camera an image acquisition, and saved as jpg format file
<william> 在 2026-01-15 上传 | 大小:2kb | 下载:0

[嵌入式Linuxb

说明:用于linux下,测试usb摄像头的基本信息,并且验证驱动是否正确安装的程序-For linux, the test usb camera basic information, and verify that the drive is correctly installed programs
<william> 在 2026-01-15 上传 | 大小:2kb | 下载:0

[单片机(51,AVR,MSP430等)adc

说明:14路网络控制继电器 下位机程序。通过串口控制程序-14 net control relay program
<Peter Shen> 在 2026-01-15 上传 | 大小:2kb | 下载:0

[单片机(51,AVR,MSP430等)DS18B20

说明:C51-DS18B20底层驱动程序,经过验证,非常好用-C51-DS18B20 driver, tested, very good use
<姚克亮> 在 2026-01-15 上传 | 大小:2kb | 下载:0

[嵌入式Linux07nand

说明:S3C6410裸板NAND FLASH驱动测试代码-S3C6410 NAND FLASH driver bare board test code
<郭志毅> 在 2026-01-15 上传 | 大小:2kb | 下载:0

[嵌入式Linux13lcd

说明:三星s3c6410 LCD驱动程序代码,用来测试LCD-Samsung s3c6410 LCD driver code, used to test the LCD
<郭志毅> 在 2026-01-15 上传 | 大小:2kb | 下载:0

[其他嵌入式/单片机内容msp430g2xx3_ta_uart2400

说明:使用定时器一CCR0硬件输出模式和SCCI数据锁 实现UART函数@ 2400波特。软件不能直接读取和 写信给RX和TX别针,相反正确使用输出模式和SCCI数据锁了。使用这些硬件特性消除了ISR 延迟效应作为硬件确保输出和输入位自锁和时机是完美的同步与定时器一个不管其他软件活动。 -Use Timer_A CCR0 hardware output modes and SCCI data latch to implement UART function @ 2400 baud
<马保> 在 2026-01-15 上传 | 大小:2kb | 下载:0
« 1 2 ... .72 .73 .74 .75 .76 30377.78 .79 .80 .81 .82 ... 33928 »

源码中国 www.ymcn.org