资源列表
[DSP编程] f2812.fft.asm
说明:利用汇编语言和TMS320F2812芯片实现FFT的算法,该算法对128点和256点很有效,使用过程中要考虑信号值不能太小-use of assembly language and TMS320F2812 chip FFT algorithm for 128 points and 256 points very effective, the process used to be considered too small signal value can not<王乾坤> 在 2025-12-30 上传 | 大小:1kb | 下载:0
[VHDL编程] ASCI_TRAFFIC_LIGHT
说明:用VERLOG实现交通灯程序,有红绿两种灯,绿灯到红灯,路灯闪10秒,可以调整红绿灯持续时间-VERLOG achieve with traffic lights procedures, two black lights, the green light to red lights, flashing lights for 10 seconds, can be adjusted duration of traffic lights<王天> 在 2025-12-30 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] NIAO
说明:4位密码检测程序 可以修改所设定的密码 适合在C51单片机上使用-four password detection procedures can modify the password set by the C51 microcontroller suitable for use<傅杰> 在 2025-12-30 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] miaobiao
说明:一个实用的秒表程序下载,请大家应用的时候注意语言环境等因素-a practical stopwatch download, please use the attention to language and other factors<s> 在 2025-12-30 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] pulsedelay
说明:c51单片机常用子程序延时(12MHz晶振,1s,10s... )-delay subroutine (12MHz crystal, 1s, 10s<杨康> 在 2025-12-30 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] Poweron_initial
说明:开机后的启动流程at89x51初始化及相关编程-boot after the start at89x51 initialization process and related programming<杨康> 在 2025-12-30 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] I2C_ICCARD
说明:I2C总线的驱动程序,可用于各种I2C方式的IC卡读写-I2C bus driver, I2C can be used for various forms of IC Card Reader<konig> 在 2025-12-30 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] SERIAL_C51
说明:C51 DOS/WINDOWS下的MCS51系列串行口(UART)的C驱动程序-C51 DOS/Windows under the MCS51 serial I (UART) C driver<WANGXIAN> 在 2025-12-30 上传 | 大小:1kb | 下载:0
[微处理器(ARM/PowerPC等)] ucos_icmp
说明:arm7下在ucos2下实现ping的完整代码,有详细的代码注释。 -ARM7 under the ucos2 ping under the complete code, a detailed code of the Notes.<zhanglin> 在 2025-12-30 上传 | 大小:1kb | 下载:0
[微处理器(ARM/PowerPC等)] ucoos2_udp
说明:arm7下ucos2下开发的完整udp协议实现代码,有完整的代码注释。-ARM7 ucos2 under development under the complete udp protocol code, a complete code Notes.<zhanglin> 在 2025-12-30 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] SJA1000_initial
说明:sja1000的初始化程序,用C编写的,很有使用价值-sja1000 initialization procedures, the preparation of the C and very useful<王文> 在 2025-12-30 上传 | 大小:1kb | 下载:0