资源列表
[单片机(51,AVR,MSP430等)] WXRAMB
说明:主要用于在单片机的监测中,片内ram 的监测读写-Mainly used in the monitoring of single-chip, chip ram monitoring reading and writing<王悦> 在 2025-07-30 上传 | 大小:1kb | 下载:0
[微处理器(ARM/PowerPC等)] nios2lcd
说明:这是niosⅡ环境下用来控制lcd的程序代码,仅供参考。-Nios Ⅱ This is used to control the lcd circumstances of the program code, for reference purposes only.<> 在 2025-07-30 上传 | 大小:1kb | 下载:0
[VHDL编程] veriloguartrx
说明:verilogHDL编写的串口检测程序,自己写的,相对其他的代码,本程序比较简短,初学者容易掌握。-verilogHDL prepared by serial testing procedures, their own writing, compared with other code, the procedure relatively brief, easy to grasp for beginners.<> 在 2025-07-30 上传 | 大小:1kb | 下载:0
[其他嵌入式/单片机内容] new2
说明:ARM嵌入式小程序源码-ARM embedded applet source code<> 在 2025-07-30 上传 | 大小:1kb | 下载:1
[单片机(51,AVR,MSP430等)] t1-4
说明:汽车发动机冷却系统流向指示程序,用于示教系统中用发光二极管指示流动方向-Automotive engine cooling system process flow instructions for teaching system using light emitting diodes directed the flow direction<xuxi> 在 2025-07-30 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] DZQ
说明:电子琴,从键盘接收字符,不回显,若为ESC键,则转EXIT,放音-Organ, to receive characters from the keyboard, do not back significantly, if the ESC key, then switch to EXIT, playback<Richard> 在 2025-07-30 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] JDQ
说明:继电器控制,设8255为A口输入,C口输出,延时5s,是否有键按下,若有则转exit,查询8255的PA0是否为高电平,若不是则继续,定时时间到,子程序返回-Relay control, set up 8255 for the A port input, C output, delay 5s, whether there is any key pressed, if so, then switch to exit, the PA0 query whether the 8255 high, if<Richard> 在 2025-07-30 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] ruisa
说明:瑞撒单片机的 应用,小日本的,改型号不是很好用-瑞撒SCM applications, small in Japan, changing models is not very good with<元元> 在 2025-07-30 上传 | 大小:1kb | 下载:0