资源列表

« 1 2 ... .91 .92 .93 .94 .95 32996.97 .98 .99 .00 .01 ... 33928 »

[单片机(51,AVR,MSP430等)juzheng-yinyuejianpan

说明:单片机控制 矩阵键盘 发出1 2 3 ...(即电子琴)(已经过测试实现)-The MCU control matrix keyboard issue 123 ... (keyboard) (has been testing implementations)
<宋道灵> 在 2025-05-30 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)chaoshengbo

说明:超声波测距 最简程序 (只把主干提出来 经测试 同样能实现效果)-Ultrasonic ranging simplest program (only trunk raised has been tested to achieve the same effect)
<宋道灵> 在 2025-05-30 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)1602

说明:对于1602液晶模块的显示功能的原理介绍-Principle introduced for the 1602 LCD display function module
<彭宝新> 在 2025-05-30 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)jingtai

说明:运用t1,t0定时器对led数码管进行静态显示,其中用到hc573锁存器-Use t1, t0 timer led digital tube static display, which uses hc573 latch
<柳力峰> 在 2025-05-30 上传 | 大小:1kb | 下载:0

[VHDL编程lcd

说明:verilog语言,该程序用于描述spartan3E开发板上的lcd的显示,对于其他的lcd显示可以从此程序修改并直接运用-verilog language, the program for describe spartan3E development board lcd display for other lcd display, can begin to changes in procedures and the use of di
<neal> 在 2025-05-30 上传 | 大小:1kb | 下载:0

[VHDL编程BUS_Control

说明:fpga上的总线控制器bus_control的控制程序,在数据采集等各个方面都会有很大的用处。-bus controller fpga bus_control control procedures, data acquisition, there will be very useful.
<neal> 在 2025-05-30 上传 | 大小:1kb | 下载:0

[VHDL编程spi

说明:spi时序控制程序。在fpga中,数据传输等都会由spi进行与主控的交换,此程序用于在数据传输中spi部分的时序控制等。-The spi Timing control procedures. In fpga, data transmission, and will by spi master exchange spi part of this procedure is used in the data transmission timi
<neal> 在 2025-05-30 上传 | 大小:1kb | 下载:0

[VHDL编程uart_rx

说明:uart通信方式的接受模块,在串口通信uart中,需要记录来自外设的数据,进行采集和时序控制,进行异步的传输。-acceptance uart communication module, serial communication uart need to record data from peripherals, acquisition and timing control, asynchronous transmission.
<neal> 在 2025-05-30 上传 | 大小:1kb | 下载:0

[VHDL编程uart_tx

说明:uart通信中的发送模块,在串口通信中,用于对外设进行通信,发送相应的指令,调节其时序逻辑。-uart communication sending module, in the serial communication, the communication of the peripheral and send the corresponding instruction, and to adjust its timing logic.
<neal> 在 2025-05-30 上传 | 大小:1kb | 下载:0

[其他嵌入式/单片机内容18b20

说明:18b20温度采集模块,源码程序!此模块精度在0.0625,完全满足工业和生活产品的开发!-18b20 temperature acquisition module, source programs! This module accuracy 0.0625, fully meet the development of industrial and domestic products!
<mygame> 在 2025-05-30 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)zigbee-interupt

说明:用C语言编译的zigbee中断,实现了zigbee中断功能。-Compiled in C language the zigbee interrupt, the implements zigbee interrupt function.
<luochen> 在 2025-05-30 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)NECI2C

说明:nec芯片硬件I2C程序,已能实现向EEPROM读写数据。-nec chip hardware I2C program has been able to read and write to the EEPROM data.
<liaowh> 在 2025-05-30 上传 | 大小:1kb | 下载:0
« 1 2 ... .91 .92 .93 .94 .95 32996.97 .98 .99 .00 .01 ... 33928 »

源码中国 www.ymcn.org