资源列表
[微处理器(ARM/PowerPC等)] adc
说明:此为ARM lpc2124上实现AD转换的代码,可直接拷贝到自己程序中使用-This is achieved ARM lpc2124 code AD conversion can be directly copied to its own procedures for the use of<songlitao> 在 2025-06-30 上传 | 大小:261kb | 下载:0
[uCOS开发] uCOS-II_for_VS2008
说明: 嵌入式操作系统入门都比较难,而搭建 uCOS-II 的环境一般需要嵌入式硬件支持,配置也相当麻烦。 为了使初学者能够学习 uCOS-II 操作系统,我特地制作了这个视频教程,供学习操作系统的初学者学习。 uCOS-II 源代码和 移植文件, 全在里面,并给出了一个程序实例,让uCOS-II 跑起来。非常不错(:-Introduction to embedded operating systems are more difficult, and the structures uCOS-II<胡辉> 在 2025-06-30 上传 | 大小:3.23mb | 下载:0
[VHDL编程] onchip_memory_0
说明:在线仿真调试的存储器代码,可在ISE或quartus下完成调试-Online simulation of the memory debugging code can be accomplished under the ISE or Quartus debugging<> 在 2025-06-30 上传 | 大小:1kb | 下载:1
[VHDL编程] jtag_uart_0
说明:jatag在nios环境下的接口代码,可在ISE或quartus下完成调试-Nios jatag environment in the interface code, can be accomplished under the ISE or Quartus debugging<> 在 2025-06-30 上传 | 大小:4kb | 下载:0
[VHDL编程] niosII_system_cpu
说明:cpu代码,可在ISE或quartus下完成调试-cpu code, can be accomplished under the ISE or Quartus debugging<> 在 2025-06-30 上传 | 大小:12kb | 下载:0
[VHDL编程] count_binary_0
说明:二进制计数器的硬件代码,可在ISE或quartus下完成调试-Binary counter hardware code, available at ISE or Quartus to complete debugging<> 在 2025-06-30 上传 | 大小:9kb | 下载:0
[单片机(51,AVR,MSP430等)] ch7013
说明:本驱动为7013 tvout驱动,将CVBS信号输出到 LCD显示,可以用来显示开机图片,或者播放节目-The driver for the 7013 tvout drive will CVBS signal output to the LCD display can be used to show the boot picture, or broadcast programs<叶建江> 在 2025-06-30 上传 | 大小:3kb | 下载:0
[单片机(51,AVR,MSP430等)] SPI_AVR_PROTEUS
说明:用两片AVR(ATmega16)单片机 实现双机通信(双向,并带反馈)。开发环境为ICCAVR。文件中不但有完整的源代码,还有用PROTEUS作的仿真图。-With two AVR (ATmega16) single-chip dual machine communications (two-way, and with feedback). Development environment for ICCAVR. Document not only complete source code, bu<贺紫恒> 在 2025-06-30 上传 | 大小:70kb | 下载:1