资源列表

« 1 2 ... .13 .14 .15 .16 .17 29018.19 .20 .21 .22 .23 ... 33928 »

[微处理器(ARM/PowerPC等)vpmrj

说明:2410下面通过MOTO手台录音程序;自己用的,还可以-2410 following the adoption of hand-Taiwan MOTO recording procedures their use can also be
<谢正茂> 在 2025-06-19 上传 | 大小:204kb | 下载:0

[DSP编程dsp_system

说明:DsP硬件设计,北理工08研究生课件,现在拿出来和大家分享-Dsp Hardware Design, North Polytechnic 08 graduate courseware, now out and everyone to share
<pkbit> 在 2025-06-19 上传 | 大小:4.38mb | 下载:0

[单片机(51,AVR,MSP430等)0`999

说明:0~999数码管和164串入并出显示的汇编编程
<黄杰深> 在 2025-06-19 上传 | 大小:1kb | 下载:0

[DSP编程FFT_in_TMS320F2812

说明:调用ti的库函数TMS320F2812芯片的fft源程序,使用DSP进行FFT运算-Ti? ? TMS320F2812??fft ? DSPFFT
<zhonghan> 在 2025-06-19 上传 | 大小:6kb | 下载:0

[单片机(51,AVR,MSP430等)ZLG_SD_Driver

说明:一份关于周立功的SD卡驱动,很值得大家阅读和参考。-A report on the week of the SD card driver Ligong, it was worthwhile for us to read and reference.
<Jason> 在 2025-06-19 上传 | 大小:19kb | 下载:0

[DSP编程test_8019

说明:tms320f2812的例程百科融创--DSP实验箱例程-TMS320F2812 encyclopedia routine financial hit me DSP experimental routines
<礼服为> 在 2025-06-19 上传 | 大小:97kb | 下载:0

[Windows CESimpleInput

说明:简单的输入法 各位多多指教 简单的输入法 各位多多指教-Simple input method that the exhibitions simple input method that the exhibitions
<hezhaokun> 在 2025-06-19 上传 | 大小:966kb | 下载:0

[单片机(51,AVR,MSP430等)PIDkongzhichengxu

说明:PID控制程序,已经在实际生产中应用,智能控制的典型例子.包含C语言源程序.-PID control procedures have been applied in actual production, a typical example of intelligent control. Contains C language source code.
<极光> 在 2025-06-19 上传 | 大小:1kb | 下载:0

[嵌入式Linuxvivi_s3c2440

说明:基于sumsung s3c2440的bootloader,此vivi已经测试过-Sumsung s3c2440 based on the bootloader, this has been tested vivi
<Jason> 在 2025-06-19 上传 | 大小:483kb | 下载:0

[单片机(51,AVR,MSP430等)WL024_ADC0832shuzidianyabiao

说明:ADC0832数字电压表LED显示.有详细注释,完整工程文件.-ADC0832 digital voltage meter LED display. Has detailed notes, a complete project file.
<极光> 在 2025-06-19 上传 | 大小:8kb | 下载:0

[单片机(51,AVR,MSP430等)potectckirl

说明:继电保护测试仪开发程序。已经是项目式的文档,你下载后,可直接使用了!当然,不对的地方,再调试一下,就行了!
<yhr> 在 2025-06-19 上传 | 大小:85kb | 下载:0

[其他嵌入式/单片机内容watchdog

说明:键控看门狗演示程序.看门狗演示程序 在16383个机器周期内必须至少喂狗一次。当晶振为11.0592M时在17毫秒内需喂狗一次。 激活看门狗后,喂狗,P0.7、P0.6引脚上的LED闪烁发光激活看门狗后,如果不喂狗,则复位 P0.1、P0.0引脚上的LED闪烁发光-Keying Demo watchdog. Watchdog demo program in the 16383 machine cycle must be at least a喂狗. When the crystal for 11.
<极光> 在 2025-06-19 上传 | 大小:7kb | 下载:0
« 1 2 ... .13 .14 .15 .16 .17 29018.19 .20 .21 .22 .23 ... 33928 »

源码中国 www.ymcn.org