资源列表

« 1 2 ... .06 .07 .08 .09 .10 30411.12 .13 .14 .15 .16 ... 33928 »

[微处理器(ARM/PowerPC等)TinyMonitor

说明:h8/3649f芯片的控制台程序,烧入芯片后启动,相当于一个bootloader,可以用命令行方式控制板上设备。-h8/3649f chips console procedures, after the start burning into the chip, which is equivalent to a bootloader, can use command-line control of on-board equipment.
<hira> 在 2025-07-20 上传 | 大小:21kb | 下载:0

[DSP编程UARTTest

说明:blackfin的UART例程-The Blackfin UART routines
<> 在 2025-07-20 上传 | 大小:128kb | 下载:0

[DSP编程SpeedTest

说明:blackfin的系统时钟测试例程-Blackfin routine testing of the system clock
<> 在 2025-07-20 上传 | 大小:91kb | 下载:0

[DSP编程Change

说明:7171的配置例程-7171 configuration routines
<> 在 2025-07-20 上传 | 大小:247kb | 下载:0

[单片机(51,AVR,MSP430等)i2ceeprom

说明:PIC单片机的I2C通信程序 C语言版本-PIC MCU I2C communication program C language version
<肖海涛> 在 2025-07-20 上传 | 大小:3kb | 下载:0

[单片机(51,AVR,MSP430等)spi

说明:PIC单片机的SPI通信子程序-PIC MCU SPI communications Subroutine
<肖海涛> 在 2025-07-20 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)usbtest

说明:使用单片机通过USB发送数据,利用VC程序接收单片机的数据,并利用画图程序进行数据的绘制,方便查看.-The use of single-chip USB to send data through the use of single-chip VC program to receive data, and use drawing program for data mapping, user-friendly.
<shu> 在 2025-07-20 上传 | 大小:7mb | 下载:0

[单片机(51,AVR,MSP430等)rpm972-h14

说明:ROHM的一款红外通讯模块 速率打4M 体积也很小-ROHM infrared communication module of a rate playing a very small volume of 4M
<王慎> 在 2025-07-20 上传 | 大小:96kb | 下载:0

[单片机(51,AVR,MSP430等)dianrong

说明:利用单片机测量电容的C51程序。通过调试,正在使用-The use of the C51 single-chip capacitance measurement procedures. Through commissioning, are using
<赵栩吉> 在 2025-07-20 上传 | 大小:11kb | 下载:0

[VHDL编程verilog_shili

说明:计数器 锁存器 12位寄存器 带load,clr等功能的寄存器 双向脚(clocked bidirectional pin) 一个简单的状态机 一个同步状态机 用状态机设计的交通灯控制器 数据接口 一个简单的UART 测试向量(Test Bench)举例: 加法器源程序 相应加法器的测试向量test bench)-Counter latch 12 registers with load, clr functions such as two-foot r
<> 在 2025-07-20 上传 | 大小:11kb | 下载:0

[嵌入式/单片机编程I2C.RAR

说明:Opencore提供的I2C代码,非常不错-I2C code Opencore provided very good
<harrybird> 在 2025-07-20 上传 | 大小:4.46mb | 下载:0

[嵌入式/单片机编程3-8TRANSFORMER

说明:译码器的逻辑功能是将已赋予特定含义的一组二进制输入代码的原意"翻译"出来,变成对应的输出高低电平信号.该程序为3-8译码器.基于VHDL,其开发环境是MAXPLUS2.-Decoder logic function is to have been given the specific meaning of a group of binary code input the original intent of translation out into the corresponding out
<weixiaoyu> 在 2025-07-20 上传 | 大小:4kb | 下载:0
« 1 2 ... .06 .07 .08 .09 .10 30411.12 .13 .14 .15 .16 ... 33928 »

源码中国 www.ymcn.org