资源列表
[matlab例程] chirp-singal-matalab
说明:按照给定的信号表达式,生成chirp信号,并计算信号的幅频和相频谱。-Expression in accordance with the given signal, to generate a chirp signal, and calculate the signal amplitude and phase spectrum.<付斌> 在 2025-11-22 上传 | 大小:1kb | 下载:0
[matlab例程] Neural-network-algorithm-source
说明:神经网络算法源程序,如SOM、HOPFIELD、CPN、BPN、BOLTZMAN、ART、ADALINE,同时提供针对不同算法的演示源程序。神经网络算法源程序-Neural network algorithm source, such as the SOM, Hopfield, CPN, BPN, BOLTZMAN, ART, ADALINE demo source code for different algorithms.<付斌> 在 2025-11-22 上传 | 大小:289kb | 下载:0
[matlab例程] MPPT-Model-
说明:光伏电池组 局部阴影时输出模型 P-U曲线 I-U曲线 simulink实现 -PV Systems Operating Under Partially Shaded Conditions<Mere> 在 2025-11-22 上传 | 大小:22kb | 下载:0
[matlab例程] SXqiaoshiquankong
说明:可用于课程设计的三相桥式整流电路matlab仿真,其参数可调-The three-phase bridge rectifier circuit can be used for curriculum design matlab simulation parameters can be adjusted<王华> 在 2025-11-22 上传 | 大小:7kb | 下载:0
[matlab例程] stochastic-dealy
说明:随机时滞程序,用于种群模型、传染病模型数值模拟-The stochastic delay procedures for the population model, the numerical simulation of the epidemic model<姬雪晖> 在 2025-11-22 上传 | 大小:1kb | 下载:0
[matlab例程] generationuwb
说明:该函数用于产生固定时间宽度的正弦脉冲。使用该函数式必须预先设定如下参数:脉冲的时间宽度Tp,正弦波的周期个数Nc,脉冲幅度A,脉冲的采样点数smp。-This function is used to generate a sinusoidal pulse of fixed time width. Using the function formula must be pre-set to the following parameters: the number Nc of the time of<Coke> 在 2025-11-22 上传 | 大小:2kb | 下载:0
[matlab例程] generation
说明:产生固定周期数的正弦脉冲信号 使用该函数时必须预先设定如下参数:正弦波的频率Fp,构成输出脉冲的正弦波的周期个数Nc,脉冲幅度A每个周期的采样点数smp。函数有两个输出:脉冲波形,以响亮sinpulse的形式输出,采样周期dt。-Produce a fixed number of cycles of the sine pulse signal Use this function must be pre-set the following<Coke> 在 2025-11-22 上传 | 大小:4kb | 下载:0
[matlab例程] drawmoxing
说明:生物模型数值仿真,预测种群数量大小,模拟平衡态的稳定性-Numerical simulation of the biological model, to predict the size of the population, to simulate the stability of the equilibrium<姬雪晖> 在 2025-11-22 上传 | 大小:2kb | 下载:0