资源列表
[matlab例程] TDOA_estimation_Newton
说明:基于MATLAB仿真程序,使用牛顿迭代法,在已知时延先验信息的基础上,对目标实现无源定位。 程序内还包含符号迭代和等值线绘图等角复杂代码。希望对研究无源定位的同志有所帮助。-MATLAB-based simulation program, using Newton s iterative method, the known delay on the basis of prior information on target to achieve passive positioning.<张威> 在 2025-11-17 上传 | 大小:4kb | 下载:2
[matlab例程] MIMO-simulation
说明:maltab语言编写的MIMO仿真程序。程序中采用双天线发射,单天线接收,通过瑞利信道,计算误码率并绘图。-maltab language MIMO simulation program. Procedures used in the dual-antenna, single-antenna receiver, through the Rayleigh channel, bit error rate calculation and drawing.<何晓雨> 在 2025-11-17 上传 | 大小:4kb | 下载:0
[matlab例程] lab1_discussion_question
说明:DSP course lab1_discussion_question<gogo> 在 2025-11-17 上传 | 大小:4kb | 下载:0
[matlab例程] the-structure-of-truss
说明:一个桁架结构的动力学响应和主动控制程序,优化算法采用了粒子群方法。仅供参考。-this dissertation discusses the dynamical response and contrlol design of a flexible trussed structure the optimal position of actuator is studied by using the particle swarm optimizer as optimization algorithm<liupan> 在 2025-11-17 上传 | 大小:4kb | 下载:0
[matlab例程] flexible-plates
说明:一个关于柔性板的模型降阶与主动控制程序,降阶方法为模态价值分析和内平衡准则,控制方法采用最优控制方法。-A flexible plate on active model reduction and control program, the value of reduced-order method for modal analysis and balancing the standards, control methods using optimal control methods.<liupan> 在 2025-11-17 上传 | 大小:4kb | 下载:1
[matlab例程] FEM2DL_Cyl
说明:应用有限元方法求解二维散射问题的matlab例程-Two-dimensional finite element method to solve the scattering problem matlab routines<陈树亮> 在 2025-11-17 上传 | 大小:4kb | 下载:0