资源列表
[matlab例程] lms-50Hz
说明:采集到的50Hz电源信号送至信号处理器作为参考信号,该参考信号在信号处理器中需经HILBERT变换变成两路正交正余弦信号X1、X2,然后采用自适应滤波器算法滤掉有用信号中的50Hz信号。-Collected 50Hz power signal to the signal processor as a reference signal, the reference signal in the signal processor requires HILBERT transform into two<周继勇> 在 2025-11-02 上传 | 大小:1kb | 下载:0
[matlab例程] SBTC
说明:MIMO系统的各种空时分组码仿真 包括2*2 alamouti编码,1/2速率的空时分组码-MIMO system simulation of space-time block codes, including 2* 2 alamouti coding, 1/2 the rate of space-time block codes<chezhengtai> 在 2025-11-02 上传 | 大小:147kb | 下载:0
[matlab例程] fdtd3D_CPML
说明:基于matlab的三维时域有限差分程序(pec边界条件),使学习时域有限差分方法的好资料。-Matlab-based three-dimensional finite difference time domain procedures (pec boundary conditions), so that learning FDTD good information.<fututudao> 在 2025-11-02 上传 | 大小:6kb | 下载:0
[matlab例程] fdtd3D_pec
说明:基于matlab的三维时域有限差分程序(cpml吸收边界),使学习时域有限差分方法的好资料。-Matlab-based three-dimensional finite difference time domain procedures (cpml absorbing boundary), so that learning FDTD good information.<fututudao> 在 2025-11-02 上传 | 大小:2kb | 下载:0
[matlab例程] fdtd3D_UPML
说明:这个身重要,基于matlab的三维时域有限差分程序(UPML各向异性的完美匹配吸收层),使学习时域有限差分方法的好资料。-The body important matlab-based three-dimensional finite difference time domain procedures (UPML anisotropic perfectly matched layer), enabling learners to FDTD good information.<fututudao> 在 2025-11-02 上传 | 大小:5kb | 下载:0
[matlab例程] mp_mc
说明:我在程序文件中所使用的计算最小费用最大流的算法并没有先用福德-富克逊法算出最大流,然后再用对偶法算出最小费用,而是将两种算法结合,最小费用和最大流一起算出-I said in my program files used in the calculation of the minimum cost maximum flow algorithm does not first Ford- Fu Dixon calculated maximum flow and then calculated the<积分> 在 2025-11-02 上传 | 大小:1kb | 下载:0
[matlab例程] AdaptiveSinpsomIntegrate
说明:该程序实现自适应的复化simpson积分。 含有三个M文件: main naadapt simpson -The program realization of adaptive restoration of simpson points. M contains the three documents: mainnaadaptsimpson<leiming691128> 在 2025-11-02 上传 | 大小:1kb | 下载:0