搜索资源列表
Technical_Requirements_of_the_L1_Interface
- 800MHz CDMA数字蜂窝移动通信网定位业务： L1接口技术要求（基本要求）。doc文档。-800MHz CDMA Digital Cellular Mobile Telecommunication Network Location Based Service:Technical Requirements of the L1 Interface （Basic Requirements）
LCD1602
- 此程序用于DS1802,LCD1602,AT89S51系列 组成的温度显示小系统，程序是我参加机电设计大赛时的一个参考程序，改一改就可以用了（只要把L1与L2的数据改动一下，就能在LCD上显示不同的字符）。-This procedure for the DS1802, LCD1602, AT89S51 series consisting of the temperature shows a small system, the progr
l1magic-1.1
- 基于matlab的稀疏表示中L1范数计算源码-the codes for L1 in sparsty representation with matlab
shan
- 用AT89S51的定时/计数器T0产生2秒钟的定时，每当2秒定时到来时，更换指示灯闪烁，每个指示闪烁的频率为0.2秒，也就是说，开始L1指示灯以0.2秒的速率闪烁，当2秒定时到来之后，L2开始以0.2秒的速率闪烁，如此循环下去。0.2秒的闪烁速率也由定时/计数器T0来完成。 -AT89S51 with the timer/counter T0 have 2 seconds of the time, whenever the arriva
TDAPR_oddyn
- The dynamics of orbit uncertainty in an unstable orbital environment are discussed with specific application to the orbit determination of a halo orbit about the Earth{Sun L1 point. This article documents a simplifie
REG-L1-IP_TS_080227
- Detalles de Camara Reg LPR
InitialPerformanceEvaluationofDFTSpreadOFDMBasedS
- Abstract—In this paper we present an initial performance evaluation of the 3GPP UTRA Long Term Evolution (UTRA LTE) uplink with baseline settings. The performance results are obtained from a detailed UTRA LTE uplin
paper02
- This paper describes an approach of implementing software based GPS receiver acquisition and tracking for L1 C/A signal on ADSP SHARC. The main objective of this paper is bring out fast GPS signal tracking method u
51_Single-Chip_computer
- 1． 闪烁灯 1． 实验任务 如图4.1.1所示：在P1.0端口上接一个发光二极管L1，使L1在不停地一亮一灭，一亮一灭的时间间隔为0.2秒。 2． 电路原理图 2． 模拟开关灯 1． 实验任务 如图4.2.1所示，监视开关K1（接在P3.0端口上），用发光二极管L1（接在单片机P1.0端口上）显示开关状态，如果开关合上，L1亮，开关打开，L1熄灭。 -51_Single-Chip_c
DES
- DES算法实验报告和代码 1.输入名字，需8个字母，不足的补叉，多余的舍去 2.将字符按ASC2码值转化为二进制，存在数值（指针）中 3.对明文做IP置换（函数） 4.将转换后的数值分成两组，赋给L0,R0，执行下列运算L1—R0,R1-L0.....重复16轮 5.将结果L0R0合并至一个数值，做IP输出-DES algorithm and code an experimental report. Enter th
planar
- This program is used for computing kinematics transformation for the planar 3-DOF, 3R robot with link length L1=3, L2=3, and L3=3(m) This program is used for calculating the modified Denavit-Hartenberg parameters
MTK_ARM_7
- mtk arm7 structure MTK for MediaTek companies to provide GSM software program. It includes five parts: -- "L1 agreement -- "Device Driver -- "Protocol Stack -- "MMI -- "WAP application MediaTek offers
CalISI
- Function Definition - C: equalizer of MISO with N.L1 X 1 F: convolved mixing matrix with N X M, with length L2 of mixing polynomial matrix, denoted by N.L2 X M M: the number of inputs N: the observ
l1magic-1.1
- 实现对图像的分块并进行压缩感知算法的恢复-Achieve the right image sub-block and recovery of compressed sensing algorithm
xhcd
- 由8031内部定时器1按方式1工作，即作为16位定时器使用，每0.1秒钟T1溢出中断一次。P1口的P1.0～P1.7分别接发光二极管的L1～L8。要求编写程序模拟一循环彩灯。彩灯变化花样可自行设计。例程给出的变化花样为：①L1、L2、…L8依次点亮；②L1、L2、…L8依次熄灭；③L1、L2、…L8全亮、全灭。各时序间隔为0.5秒。让发光二极管按以上规律循环显示下去。-By 8031 according to an internal t
padm_unc
- 求解l1优化问题，在压缩传感中有应用，概算发可以求解三个模型：BP，BPDN和约束版本-Solves L1 problems arsing from Compressive sensing, compressive sampling and sparse optimization
l1_tf_matlab
- 实用matlab进行l1性能指标下的滤波器设计，可以针对传递函数模型或者零极点模型。-Practical matlab to l1 performance under the filter design can be for the transfer function model or a model of zero-pole.
code
- 稀疏编码的工具包，用matlab实现，数学上是求解l1 norm最小化-toolkit for sparse coding
L1
- 430PWM自动输出低功耗模式，利用outmod7-430PWM Automatic output low-power mode
MTK_Flash_Tool_v3.908.00_(2009.02.24)
- Another MTK Flash Tools for MTK Firmware