搜索资源列表
UPS
- 这个是太阳能控制器的，控制软件， 里面有充电管理等内容，希望大家-This is a solar controller, control software, there are content management, charging, I hope we look at the
switchpower_mage48
- 应用mage48IC编写的充电器程序功能如下： 1.充电指示 2.电量显示 3.电池保护 4.自动断电 5.充电电压选择12V24V 本程序无任何问题已经量产 -Application procedures mage48IC function charger prepared as follows: 1. Recharging instructions 2. Electricity display 3. Ba
battery.asm
- 通过定时器定时从AD上读取数据，根据不同的电压选择不同的控制充电方案，使用PWM控制输出脉宽来控制电流-failed to translate
rfid_gate
- 一套完整的门禁系统(原理图+源程序)，包括电源充电，门禁cpu-A complete set of access control system (schematic diagram+ source)
charg
- 使用充电器电路集锦，对实用的充电电路进行讲解，非常全面-Highlights the use of the charger circuit of the charging circuit to carry out practical explanations, very comprehensive
taiyangneng
- 通过单片机采样电压AD值，控制太阳能板充电，有过流过载保护。-AD through the single-chip voltage sampling value, control charging solar panels, there are over-current overload protection.
an137swf300lionbatterycharger
- 基于C8051F300的锂电池充电解决方案.包含文档和源程序.-C8051F300-based lithium battery solutions. Contains documentation and source code.
PTC_SER
- 串联式混合动力电动汽车的能量控制策略，恒温控制策略，当电池SOC在合适范围内依靠电机驱动，发动机关闭与否取决于汽车行驶所需要的能量。低于SOC下限时，依靠发动机驱动，多余能量为蓄电池充电。高于上限时关闭发动机依靠电机驱动。-Series Hybrid Electric Vehicle Control Strategy of energy, constant temperature control strategy, when the b
Public
- LF2407a 用于继电保护的一些程序。包括DS1305E的读写充电。eeprom ,can,spi,lcd等-LF2407a some of the procedures used for protective relaying. Including DS1305E charge to read and write. eeprom, can, spi, lcd, etc.
CT3583
- 充电管理ic的测试方案，主要集中两灯及三灯模式的转换-Charge Management ic testing program focused on two lights and three light paradigm shift
POWER07-09-11
- 电源控制程序，用于太阳能和交流充电，是理想的控制程序-Power control program for solar energy and the exchange of charge, is the ideal control program
N10_TestBattery0
- 工厂产线测试电池软件，VC编写，用来测电池状态，充电百分比，电流大小及温度！-code testing the battery of the notebook computer
ch2example2prg1
- 仿真电容充电过程，用matlab语言实现-Capacitor charging process simulation using matlab language implementation
power-li
- 一个锂电充电电路，刚开始应用，已生产多款设备，目前还没有发现什么问题。注意，只能管理一节锂电。-A lithium battery charging circuit, the beginning of application, has produced a variety of equipment, there is not currently a problem. Note that only manage a lithium bat
ni-mhcharge
- 镍氢电池详细的充电方法以及C代码,不错的文章.-Ni-MH battery charging methods and the detailed C code, a good article.
mcs_PWM
- 本方法的基本思想就是利用单片机具有的PWM端口，在不改变PWM方波周期的前提下，通过软件的方法调整单片机的PWM控制寄存器来调整PWM的占空比，从而控制充电电流-The basic idea of this method is the use of microcontroller has the PWM ports, without changing the PWM square wave cycle, under the premis
ATmega16_Power
- ATmega16 AVR单片机作电源检测。包括充电，电源输出测试等功能-ATmega16 AVR microcontroller for power detection. Including charging, power output test function
main
- PIC10f220 完成的电池充电保护 -PIC10f220 complete battery charging protection
batterycharge
- 通过单片机程序控制对电池分时充电，并通过热敏电阻实时测温，防止电池充电过程过度发热-MCU programmed by time-charging the battery and, through the thermistor temperature measurement, battery charging process to prevent over-heating
xudianchikuaisuchongdianxitong
- 单片机快速充电系统的研究，很详细的论述了整个过程的充电系统，欢迎交流-SCM rapid charging system, is discussed in detail the whole process of charging system, welcomed the exchange of