搜索资源列表
软件模拟USART
- PIC模拟异步串行通讯UART。用TMR0实现定时查询。任何带中断的PIC上都可以实现。可用此法扩展多个串口。-PIC simulation asynchronous serial communications UART. Timing TMR0 with inquiries. Any interruption with the PIC are to be attained. This method can be extended se
PIC_source_31
- 16C84做的智能卡程序,滚动码应用原程序,16c54四位LED时钟显示程序,红外应用源程序集1,用PIC12C508509 控制一个步进电机源程序,模拟数据采器 USART
ad-USART
- Data Acquisition Device 数据采集办法 * Module Descr iption组件描述: * Analog Data Acquisition模拟数据采集器组件使用 EE314 * 设备接口通过RS232串行口serial port到PC，同时提供协议protocol支持最多5个对 * 手方频道
软件模拟USART
- PIC模拟异步串行通讯UART。用TMR0实现定时查询。任何带中断的PIC上都可以实现。可用此法扩展多个串口。-PIC simulation asynchronous serial communications UART. Timing TMR0 with inquiries. Any interruption with the PIC are to be attained. This method can be extended se
PIC_source_31
- 16C84做的智能卡程序,滚动码应用原程序,16c54四位LED时钟显示程序,红外应用源程序集1,用PIC12C508509 控制一个步进电机源程序,模拟数据采器 USART-16C84 make smart card procedures, the application of original procedures for rolling code, 16c54 four LED clock display program, one
ad-USART
- Data Acquisition Device 数据采集办法 * Module Descr iption组件描述: * Analog Data Acquisition模拟数据采集器组件使用 EE314 * 设备接口通过RS232串行口serial port到PC，同时提供协议protocol支持最多5个对 * 手方频道 -Data Acquisition Device data acquisition m
m_usart
- PIC单片机模拟串口收发.可设置波特率。8位9位可选-PIC microcontroller analog serial transceiver. You can set the baud rate. 8 9 optional
usart
- 用stm8MCU写的中继器程序，RS485通信，主机发送的数据经过中继器发给从机有一路是I/O模拟USART-Written by stm8MCU relay program, RS485 communication, the host sends the data through the repeater issue with the way the slave is the I/O Analog USART
5780bcf5-da04-4cf6-b388-1f3d01c4896c
- STM32框架,USING 3.X库 准备以后产品换STM3２,写了个例程,网上的都是零碎的,这个例程可以直接用,不喜欢官方的结构,改了一下.内容有GPIO SYSTIC EXIT ADC USART FLASH ＥＥＰＲＯＭ（ＦＬＡＳＨ模拟）．存下以后自已也能用．固件库有点大就不一起上传了．使用MDK4 -STM32 fr a mework, USING 3.X library prepared after the product
stm32adc2dmausart
- STM32的ADC采集模拟电压，转换结果以DMA方式传输给USART，USART通过串口发送到上位机-STM32 of the ADC analog voltage acquisition, the conversion results mode DMA transfer to the USART, USART to the PC via the serial port
usart
- pic16f877a单片机的模拟串口的发送与接收程序-51 single-chip analog serial port to send and receive data program
USART-STM32
- STM32F103串口应用程序,练习内容是模拟串口。让你了解STM32的应用。-STM32F103 USART
51-USART-mpu6050
- MPU6050的51程序，采用模拟IIc总线，亲测可用，可以通过串口发送到计算机上面，然后通过串口波形软件即可显示波形，程序方便移植STM32-MPU6050 51 program, the simulation of IIc bus, dear test is available, can be sent through the serial port to the computer, and then through the ser
Simulate-USART
- 单片机程序，用于模拟USART通信功能，可以修改之后应用于PIC、51等开发项目中-MCU program, used to simulate USART communication functions can then be applied to modify the PIC, 51 and other development projects
STM32-Flash-when-USART-enable
- 在其产品设计中，经常会使用STM32片上Flash模拟一个EEPROM的功能，用于存贮数据。在软件调试时，发现开启此功能，会影响到USART通信，导致偶尔发生个别数据接收不到的现象。本文档详细介绍原因和解决方法。-vIn its product design, often using the STM32 chip Flash EEPROM simulates a function for storing data. When softw
I2C-USART
- STM32编程。通过I2C把EEPROM里的数据发往串口，并比较从串口接收到的数据，模拟一个智力问答的小情景。能把历史最高分纪录在EEPROM里-STM32 programming. Block through the I2C EEPROM in the data sent to a serial port, and compare the serial port to receive the data, the simulation
USART-TO-MNUSART
- MCU avr ATmega168 实现485串口与模拟串口间数据透传 ICCAVR源码。自己写的-MCU avr ATmega168 实现485串口与模拟串口间数据透传 ICCAVR源码。自己写的
(STM32)ADC DMA USART(仅必须的C文件不含工程)
- simulink控制系统模拟,关于信号的采集(simulation of simulink's control)
Sim_USART
- 在STM32平台 模拟USART通讯（1bit起始位，1bit终止位，8bit数据，无奇偶校验）(Simulation of USART communication on STM32 platform)