资源列表

« 1 2 ... .14 .15 .16 .17 .18 30019.20 .21 .22 .23 .24 ... 33928 »

[单片机(51,AVR,MSP430等)STC12-18b20

说明:基于STC12的18B20温度检测程序 屏幕为OLED12864 1.3寸-STC12 based 18B20 temperature detection program screen for OLED12864 1.3 inch
<WR> 在 2026-01-17 上传 | 大小:49kb | 下载:0

[单片机(51,AVR,MSP430等)motor

说明:步进电机驱动源码(包含加减速,细分等功能)-Stepper motor driver source code (including acceleration and deceleration, subdivision and other functions)
<bolin> 在 2026-01-17 上传 | 大小:7kb | 下载:0

[单片机(51,AVR,MSP430等)i2cdevlib

说明:mpu6050 的函数库,可以实现dmp功能
<wolfray> 在 2026-01-17 上传 | 大小:1.43mb | 下载:0

[单片机(51,AVR,MSP430等)AD9833

说明:ad9833 datasheet ad9833 datasheet-ad9833 datasheet ad9833 datasheet
<回繁宁> 在 2026-01-17 上传 | 大小:288kb | 下载:0

[DSP编程SolarMicroInv_F2803x

说明:这是TI公司的一个关于光伏并网的dsp程序。-This is a DSP program of TI company,which is used in grid-connecd of solar inverter.
<梁劲> 在 2026-01-17 上传 | 大小:37kb | 下载:0

[VHDL编程02_run_flash_led

说明:在这一个实验,我们要以上图作为基础,建立一个并行操作的流水灯模块。扫描频配置定为100 Hz,而每一个功能模块在特定的时间内,将输出拉高。-In this experiment, we should above figure as the foundation, set up a parallel operation of flowing water light module. Scanning frequency configuration at 100 Hz, and each functi
<杨军利> 在 2026-01-17 上传 | 大小:4.73mb | 下载:0

[VHDL编程03_key_detect_1

说明:键盘抖动的Verilog实现,设计的方法主要是由“电平检查模块”和“10ms延迟模块”组合合成。-Keyboard shaking Verilog implementation, the method of design is mainly by level examination module and 10 ms delay module combinatorial synthesis.
<杨军利> 在 2026-01-17 上传 | 大小:2.98mb | 下载:0

[VHDL编程LED

说明:LED流水灯程序,可以实现安50分频的频率流水,文件中值包含了必要的.v文件,具体工程需要自己创建-LED light water program, can realize frequency water, Ann 50 points frequency value of the file containing the necessary. V file, need to create your own specific project
<mikegody> 在 2026-01-17 上传 | 大小:2kb | 下载:0

[其他嵌入式/单片机内容NES

说明:非常完整的arm7的汇编nes模拟器核心.-nes emulator compilation of core arm7
<zys> 在 2026-01-17 上传 | 大小:118kb | 下载:0

[单片机(51,AVR,MSP430等)ExtiKey

说明:基于STM32,PB0连接到key1,PB0配置为线中断模式,key1按下时,进入线中断处理函数,LED1状态取反。-PB0 connected to key1, PB0 configured for line break mode, press key1 into line interrupt handler LED1 status negated.
<LTQ> 在 2026-01-17 上传 | 大小:2.04mb | 下载:0

[单片机(51,AVR,MSP430等)stc-spi-com

说明:单片机的SPI通信开发代码,自己编写的模块,可以拿来直接使用。-MCU SPI communication development code, write your own module, can be used directly.
<沈沁> 在 2026-01-17 上传 | 大小:13kb | 下载:0

[VHDL编程alarm_clock

说明:二十四小时进制 实现闹钟、时间的切换 实现时间的调整 调整时间能在相应的位置实现闪烁功能-Twenty-four hours hex To switch the alarm, time To achieve the adjustment time Adjust the time flashing function can be achieved in the corresponding position
<李威> 在 2026-01-17 上传 | 大小:10.4mb | 下载:0
« 1 2 ... .14 .15 .16 .17 .18 30019.20 .21 .22 .23 .24 ... 33928 »

源码中国 www.ymcn.org