资源列表
[嵌入式/单片机编程] LED_Screen
说明:STM32F103控制LED点阵大屏256*64的扫描驱动程序。(STM32F103 controls the scanning driver of 256*64 LED dot matrix large screen.)<皓天01> 在 2025-12-29 上传 | 大小:3kb | 下载:0
[单片机(51,AVR,MSP430等)] LT8920 Tx+Rx Demo
说明:用arduino板实现LT8920无线收发,IO口要根据自己修改配置,“”loop*”根据需要改成发送或者接收(Using Arduino board to realize LT8920 wireless transceiver, IO port should be modified according to its configuration, and "loop*" should be changed to send or receive according to nee<Zheng Nick> 在 2025-12-29 上传 | 大小:3kb | 下载:0
[单片机(51,AVR,MSP430等)] ST75256
说明:ST75256 SPI IIC 6800_parallel 8080_parallel 的驱动以及显示程式(ST75256 SPI IIC 6800_parallel 8080_parallel driver and display program)<程序員> 在 2025-12-29 上传 | 大小:3kb | 下载:2
[微处理器(ARM/PowerPC等)] SHT3X-51驱动
说明:温湿度传感器sht30驱动程序,可以移植到51单片机中,(The sht30 driver of temperature and humidity sensor can be transplanted into 51 single chip computer.)<45644547878> 在 2025-12-29 上传 | 大小:3kb | 下载:0
[单片机(51,AVR,MSP430等)] AD7799
说明:AD7799 AD转换芯片,电压采集驱动程序。(AD7799 AD conversion chip, voltage acquisition driver.)<guanjingxin> 在 2025-12-29 上传 | 大小:3kb | 下载:0
[单片机(51,AVR,MSP430等)] fuzzy_pid
说明:基于模糊控制的一种自适应PID算法,适用于各种嵌入式开发(An adaptive PID algorithm based on fuzzy control for various embedded development)<chinazc123> 在 2025-12-29 上传 | 大小:3kb | 下载:0
[单片机(51,AVR,MSP430等)] SOC
说明:电池组的SOC估算方法程序,采用安时积分法(The procedure of SOC estimation for battery packs is based on the time integration method.)<776528> 在 2025-12-29 上传 | 大小:3kb | 下载:0
[单片机(51,AVR,MSP430等)] lesson33
说明:Arduino针对DHT11的开发程序,需要库文件,可以测量空气温度和湿度。(Arduino's development program for DHT11 requires library files to measure air temperature and humidity.)<duoduoduoduodd> 在 2025-12-29 上传 | 大小:3kb | 下载:0
[单片机(51,AVR,MSP430等)] INA233
说明:用于监测产品的电压和电流的监测,监测的精度较高,监测电压可以达到36V,监测电流使用并联小电阻方式,并联电阻电压可以达到81mV;(It is used to monitor the voltage and current of the product. The monitoring accuracy is high. The monitoring voltage can reach 36V. The monitoring current uses the parallel small resi<蚂蚁的微笑> 在 2025-12-29 上传 | 大小:3kb | 下载:1
[单片机(51,AVR,MSP430等)] LED
说明:stm32+ULN2003+28BYJ驱动步进电机,插上电机后,指示灯根据状态亮,实现电机转动。(STm32+ULN2003+28BYJ drives the stepper motor. After inserting the motor, the indicator lights up according to the state to realize the motor rotation.)<KLWG> 在 2025-12-29 上传 | 大小:3kb | 下载:0