资源列表

« 1 2 ... .74 .75 .76 .77 .78 31179.80 .81 .82 .83 .84 ... 33928 »

[单片机(51,AVR,MSP430等)IICfor430

说明:一个模拟IIC程序, 运行于430片子。-IIC a simulated procedure, running on 430 film.
<agui> 在 2025-05-16 上传 | 大小:1kb | 下载:0

[VHDL编程8255_IO_vhdl

说明:VHDL语言设计 8255并行I/O接口芯片-VHDL Language Design 8255 Parallel I/O interface chip
<weixj> 在 2025-05-16 上传 | 大小:1kb | 下载:0

[VHDL编程adc0809

说明:ADC0809的驱动程序,经实验正确可靠,实用-ADC0809 driver, after the experiment to accurate and reliable, practical
<chenyang> 在 2025-05-16 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)jiema

说明:红外 解码-Infrared decoder
<李空> 在 2025-05-16 上传 | 大小:1kb | 下载:0

[VHDL编程adder

说明:此程序为用VERLOG HDL编写的一个完整的3位加法器。-This procedure for VERLOG HDL prepared with a full adder 3.
<liuwei> 在 2025-05-16 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)mcu

说明:单片机无线发射代码,检测键盘后,发射载波-Single-chip wireless launch code, test the keyboard, the launch carrier
<> 在 2025-05-16 上传 | 大小:1kb | 下载:0

[微处理器(ARM/PowerPC等)8253

说明:编写了对微机8253芯片的驱动程序,可以使主板产生一定频率的音乐-卤 脿脨
<吴丹> 在 2025-05-16 上传 | 大小:1kb | 下载:0

[VHDL编程csma030390

说明:模拟Ethernet帧发送过程,使读者熟悉Ethernet帧的数据发送流程-Simulation of Ethernet fr a mes sent process, so that readers familiar with the Ethernet data fr a mes to send flow
<猪八戒> 在 2025-05-16 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)DS18B20

说明:AVR控制DS18B02的程序接口!可以直接使用该程序控制它,采集当前的数据!-AVR control procedures DS18B02 interface! Can directly use the control it, and collecting current data!
<廖晶晶> 在 2025-05-16 上传 | 大小:1kb | 下载:0

[VHDL编程seg7_1

说明:用VHDL描述一个让6个数码管同时显示的控制器,同时显示0、1、2、3、4、5这6个不同的数字图形到6个数码管上,输入时钟调节频率,使得能够观察到稳定显示的6个数字。可异步复位-Using VHDL descr iption of a six digital tube display controller at the same time, also showed that six different 0,1,2,3,4,5 digit
<wx> 在 2025-05-16 上传 | 大小:1kb | 下载:0

[VHDL编程zmd_1

说明:用VHDL描述一个由8个发光二极管组成的走马灯。有系统复位。单点移动模式:一个点在8个发光二极管上来回的亮。幕布式:从中间两个点,同时向两边依次点亮直至全亮,然后再向中间点灭,依次往复。采用拨码开关转换显示模式。 -Use VHDL to describe an 8-digit LED lantern. System has reset. Single point of mobile model: a point in eight
<wx> 在 2025-05-16 上传 | 大小:1kb | 下载:0

[VHDL编程zmd_1

说明:用VHDL描述一个由8个发光二极管组成的走马灯。有系统复位。单点移动模式:一个点在8个发光二极管上来回的亮。幕布式:从中间两个点,同时向两边依次点亮直至全亮,然后再向中间点灭,依次往复。采用采用一个按键转换显示模式。 -Use VHDL to describe an 8-digit LED lantern. System has reset. Single point of mobile model: a point in eigh
<wx> 在 2025-05-16 上传 | 大小:1kb | 下载:0
« 1 2 ... .74 .75 .76 .77 .78 31179.80 .81 .82 .83 .84 ... 33928 »

源码中国 www.ymcn.org