资源列表

« 1 2 ... .08 .09 .10 .11 .12 813.14 .15 .16 .17 .18 ... 4310 »

[VHDL编程ASANDJTAG

说明:
<xiaozhaofeng> 在 2025-06-20 上传 | 大小:140kb | 下载:0

[VHDL编程pinlvji_5

说明:用Verilog语言实现的5位频率计设计,为实现功能验证,测频信号是由内部时钟源分频得到,为25KHZ,数据输出为串行输出。使用的硬件资源是altera公司的EPM7218,晶振为40MHZ。-Verilog language used to achieve the five frequency meter design, to achieve functional verification, signal frequency measurement by the internal clock
<李晓宇> 在 2025-06-20 上传 | 大小:288kb | 下载:0

[VHDL编程R_12C

说明:完成W25x ,M25p系列flash的读操作!经验证无误!-W25x ,M25p flash
<caofeng> 在 2025-06-20 上传 | 大小:2.71mb | 下载:0

[VHDL编程uart_vhdl

说明:VHDL语言的实现标准的UART串口,并可以多次例化成多串口的-The realization of VHDL language standard UART serial port
<刘宏> 在 2025-06-20 上传 | 大小:10kb | 下载:0

[VHDL编程fft_VHDL

说明:使用altra的quartus8.1作为开发环境,用硬件语言VHDL实现了fft的变化-Altra as quartus8.1 use the development environment, language VHDL hardware changes to achieve the fft
<黄易飞> 在 2025-06-20 上传 | 大小:70kb | 下载:0

[VHDL编程FPGA-Design

说明:
<罗春成> 在 2025-06-20 上传 | 大小:35kb | 下载:0

[VHDL编程crc_verilog_xilinx

说明:CRC,对于研究通信的有重要意义.利用VERILOG实现8位,16位等CRC原理,-CRC, the study of communication are important. VERILOG to achieve the use of 8, 16, such as CRC principle,
<> 在 2025-06-20 上传 | 大小:10kb | 下载:0

[VHDL编程user_logic_Open_I2C

说明:基于sopc系统的iic总线设计,提供关于片上系统的iic设计源代码及驱动-iic of system on programming chip
<yly> 在 2025-06-20 上传 | 大小:12kb | 下载:0

[VHDL编程VHDLCODE

说明:VHDL的一些典型源代码,有七段数码管译码器,格雷码转换为二进制码,八位数字比较器等等。-Typical VHDL source code, there are Seven-Segment LED Decoder, Gray code is converted to binary code, the eight figures and so on.
<李军> 在 2025-06-20 上传 | 大小:157kb | 下载:0

[VHDL编程pmw2ppm

说明:Vhdl code PPM to pwm converte
<SANTOSH> 在 2025-06-20 上传 | 大小:4kb | 下载:0

[VHDL编程ad5510

说明:TLC5510 的状态机控制程序,控制方法简单,并已经测试通过。-TLC5510 control procedures of the state machine, control method is simple and has the test.
<liangwh> 在 2025-06-20 上传 | 大小:1kb | 下载:0

[VHDL编程CORDIC_angel_application

说明:cordic IP,用于倾角传感器中的计算。-cordic IP, used in the calculation of angle sensor.
<forrest1> 在 2025-06-20 上传 | 大小:150kb | 下载:0
« 1 2 ... .08 .09 .10 .11 .12 813.14 .15 .16 .17 .18 ... 4310 »

源码中国 www.ymcn.org