搜索资源列表
FSKmodulationanddemodulation
- FSK调制与解调，整个设计基于ALTERA公司的QuartusⅡ开发平台，并用Cyclone系列FPGA实现。所设计的调制解调器具有体积小、功耗低、集成度高、软件可移植性强、扰干扰能力强的特点,符合未来通信技术设计的方向。-FSK modulation and demodulation, the entire design is based on ALTERA' s development platform Quartus Ⅱ,
Low-powermodeMC9S08GBGT
- MC9S08GBGT的低功耗模式，飞思卡尔单片机的很好的应用-MC9S08GBGT low-power mode, a good Freescale MCU Application
GSM-LownoiseAmplifierModule-to-Monitor-the-process
- GSM低噪声放大器模块监控处理程序，主功能包括输入输出功率检测，最大输出功率控制，器件坏告警等。-GSM low-noise amplifier module to monitor the process, the main features include detection of input and output power, maximum output power control, alarm devices, such as
chap06
- ex5_1 I-型线性相位FIR滤波器 ex5_2 II-型线性相位FIR滤波器 ex5_3 III-型线性相位FIR滤波器 ex5_4 IV-型线性相位FIR滤波器 ex5_5 矩形窗频响 ex5_6 希尔伯特变换器设计－汉宁窗 ex5_7 低通滤波器设计－汉明窗 ex5_8 带通滤波器设计－布莱克曼窗 ex5_9 低通滤波器设计－凯塞窗 ex5_11 频率采样技术：低通，朴素法 ex5_12
A-5.8-GHz-CMOS-low-noise-amplifier-for-WLAN-applic
- 一个用于WLAN的5.08GHz的低噪声放大器的设计论文（英文的，多伦多大学的硕士论文）-One for the WLAN of the 5.08GHz low-noise amplifier design thesis (in English, the University of Toronto master' s thesis)
Low_HighPassFilter
- Demonstrate on Low & High Pass Filter.
aliasingfilter
- 1）设计Butterworth型音频抗混叠滤波器； 2）参数： 下通带频率300Hz；上通带频率3400Hz； 下阻带频率280Hz；上阻带频率3600Hz； 通带最大衰减0.3dB； 阻带最小衰减40dB； 3）采用一低通滤波器和一高通滤波器级联； 4）分别确定LPF和HPF的性能指标； 5）求出两滤波器的系统函数和频率响应，并画出其幅频特性曲线； 6）求整个滤波器的系统函数和频率响应，并画出其幅频
rmfilter
- 低通滤波器在QUARTUS7.0开发环境下的文本与框图结合的实现方法的源代码-Low-pass filter QUARTUS7.0 development environment in the text and diagram combination of methods to achieve source code
Low-power
- 1.通过键盘、LCD来进行超低功耗实验 2 在一段时间内，如果用户没有进行按键操作，系统将进入“睡眠”－－低功耗状态 3 用户按键后，系统从低功耗状态转到正常的工作状态 4 在非低功耗状态下，程序接收键盘按键执行加法器操作(因为键盘和LCD限制不能实现复杂 5 的功能,如乘法、减法、除法等）.-1. Through the keyboard, LCD for ultra low-power experiment 2 ov
wb_lpc_latest.tar
- Wishbone to LPC (Low-Pin Count) Bridge, includes master and slave modules. Supports 8-bit I/O Read and Write cycles, 8-bit Memory Read/Write cycles, DMA cycles, and up to 32-bit Firmware memory read/write cycles. Serial
LNA_Design
- This document is about design Low Noise Amplifier with ADS.
chengxu
- 设计一个数字FIR低通滤波器，其技术指标如下： Wp=0.2pi Rp=0.25Db Ws=0.3pi As=50db 试写出MATLAB设计的源程序。-Design a digital FIR low-pass filter, the technical indicators are as follows: Wp = 0.2pi Rp = 0.25Db Ws = 0.3pi As = 50db test designed
MATLABchebhigh2cheblow1
- 自己做的： （一）用双线性变换法设计并用实验系统实现一个三阶的契比雪夫Ⅰ型低通数字滤波器，其采样频率Fs =8KHz，1DB通带边界频率为fp=2KHz。 （二）用双线性变换法设计并用实验系统实现一个三阶的契比雪夫Ⅱ型高通数字滤波器，其采样频率Fs =16KHz，阻带边界频率为fst =4KHz，As=20dB。 -(A) design using the bilinear transformation method and
filter_test
- low pass filter module
HightFilterAndLowFilter
- 实现正逆傅里叶变换，并在此基础上实现各种高低通滤波器，采用OPENCV实现。图像只针对2的整数次幂的方图-implement kinds of high filters and low filters in OPENCV based on implementing the FFTs and IFFTS.
IIR
- IIR 数字滤波器设计：模拟低通巴特沃思滤波器、模拟低通切比雪夫1型滤波器、模拟低通切比雪夫2型滤波器、模拟椭圆低通滤波器-IIR Digital Filter Design: Analog low-pass Butterworth filter, analog low-pass Chebyshev Type 1 filter, analog low-pass Chebyshev type 2 filter, analog ellipt
triblebge3h
- 三相桥双极性PWM控制Simulink仿真，另加一滤波器观看PWM经过低通滤波后的波形，适合电力电子初学者-Three-phase bridge bipolar PWM control Simulink simulation, plus a watch PWM filter through after the low-pass wave filter for power electronics for beginners
triblebgesuperposition
- 三相桥双极性PWM控制Simulink仿真，叠加一些其他信号，另加一滤波器观看PWM经过低通滤波后的波形，适合电力电子初学者-Three-phase bridge bipolar PWM control Simulink simulation, superimposed a number of other signals, plus a watch PWM filter through after the low-pass wave f
EINT
- philips LPC2103 ARM EINT0 EINT3的向量中断试验程序，P0.16为中断EINT0低电平中断，P0.14中断EINT3低电平中断，当不同的中断产生是P0.17和p0.18产生不同的PWM信号。-philips LPC2103 ARM EINT0 EINT3 vector interrupt the test procedure, P0.16 for the low-level disruption EINT0
KTAVMulticast
- 组播实现 音视频同步传输，延时极低。提供详细外部接口定义。-Multicast audio and video simultaneously to achieve transmission, extremely low latency. Provide a detailed definition of external interfaces.