搜索资源列表
shuzimiaobiao
- 数字秒表,要求从00:00秒开始计时,最大计时时间为99:99秒。并且具有启动、暂停和清零(复位)等功能。-Digital stopwatch, requiring from 00:00 seconds to start the timer, the maximum time of 99:99 seconds time. And has a start, pause, and clear (reset) and other functi
digital_clock
- 用VHDL语言实现常用的数字秒表,并在Sparten3E FPGA上运行通过。-VHDL language commonly used with a digital stopwatch, and Sparten3E FPGA run through.
Two-digital-stopwatch-
- 二位数字秒表 具有记时,开始,暂停,结束,清零,功能。-Two digital stopwatch has in mind, start, pause, end, clear, functional.
Digital-stopwatch-schematic
- 数字式秒表原理图及仿真波形,真实反映数字秒表内部结构-Digital stopwatch schematic and simulation waveforms, a true reflection of the internal structure of digital stopwatch. . .
seccount
- 用VHDL语言设计电子数字秒表。包含相关文件及说明,用户可以在Xilinx ISE 环境下运行。-With VHDL language design digital stopwatch. Contains the corresponding code and all documents. Users can Xilinx ISE environment in operation
clk
- 这是一个数字秒表的设计。几时周期为0.01s-1h。带有计数器的清零端,还有一个秒表的计时起止控制开关,最后计时信息显示在数码管上。-This is a digital stopwatch design. When a period of 0.01s-1h. Cleared with the end of the counter, and a stopwatch start and end time-control switch, th
stopwatch
- 多功能数字秒表,可以实现系统复位,暂停,等计时功能,经验证正确-stopwatch
stopwatch1
- 用vhdl实现的数字秒表,显示四位值,最大计时时间为99.99s,全部通过验证,并且在FPGA上得到很多的结果-Using vhdl implementation of the digital stopwatch display four values, the maximum time time 99.99s, all validated, and get a lot of the FPGA results
suzimiaobiao
- 数字秒表的实现,我还写个具体的过程要求等,-there is function of clock,it very useful
EDA
- EDA实验指导书,包括简单逻辑电路设计与仿真、寄存器电路设计仿真与下载、数字秒表的设计等-EDA experimental instructions, including simple logic circuit design and simulation, circuit design, simulation and register to download, the design of digital stopwatch
stopwatch
- 自己写的一个数字秒表,已经在实验板上面验证通过-Write a digital stopwatch, have been verified by experiments above board
stopwatch
- 基于单片机的,用婚变语言实现的数字秒表。-Microcontroller-based digital stopwatch
clock
- 数字秒表计数 vhdl 译码器 分频器 计数器 报警器-stopwatch counter
shuozidianyabiao
- 这是一段基于xs128的 cw编程环境 数字秒表的程序- This is a of the xs128 cw programming environment-based digital stopwatch program
MiaoBiao
- 基于嵌入式的数字秒表的设计要求有闹钟和年月日的显示-Based on the design requirements of the embedded digital stopwatch, alarm clock and date display
danpianji
- 基于DS1302的数字秒表的设计要求显示年月日和设定闹钟等-Based on the design requirements of the DS1302 digital stopwatch display month, day and set the alarm
EDAshuzimiaobiao
- EDA数字秒表 一、总体设计要求: 设计一个数字秒表,共有6位输出显示,分别为百分之一秒、十分之一秒、秒、十秒、分、十分;秒表的最大计数容量为60分钟,当计时达60分钟后,蜂鸣器报警;秒表还需有一个启动信号和一个归零信号,以便秒表能随意启停及归零。 二、技术要点: 1.秒表的逻辑结构主要由显示译码器、分频器、十进制计数器、六进制计数器和报警器组成。 2.最关键的是精确的100Hz计时脉冲如何获得,可由高频时钟信号经分
miaobiao
- 利用单片机实现数字秒表,8位数码管显示,最大24小时-MCU digital stopwatch, eight digital display, up to 24 hours
dclock
- 数字秒表设计:设计计时范围为0.01—1h的数字秒表,程序分为分频,计数和显示三个模块-Digital stopwatch design: the design timing range of 0.01-1h digital stopwatch program is divided into three divider, counting and display module
DYQ
- 点烟器测试台程序,(两组自动检测的十位数字秒表)-Cigarette lighter test bed program (two sets of automatic detection of ten digital stopwatch)