资源列表

« 1 2 ... .78 .79 .80 .81 .82 1983.84 .85 .86 .87 .88 ... 4310 »

[VHDL编程SRAM_test

说明:SRAM的一个控制器,内附文档说明。设置地址和输入数据,完成写功能,再次输入地址,完成读功能。-An SRAM controller, included documentation. Set the address and input data, complete the write function, enter the address again to complete the reading function.
<李成> 在 2025-06-04 上传 | 大小:653kb | 下载:0

[VHDL编程DDR2_32Mx16_VHDL

说明:ddr2 implementation software for xilinx 10.1 sp3
<manish> 在 2025-06-04 上传 | 大小:1.66mb | 下载:0

[VHDL编程h_adder

说明:一个二位全加器的VHDL实现程序,能够完美在Quartus上运行-a h_adder write in VHDL,can work well on Quartus
<许万春> 在 2025-06-04 上传 | 大小:1kb | 下载:0

[VHDL编程Circuit-Design-with-VHDL

说明:it is usful book for VHDL
<samar> 在 2025-06-04 上传 | 大小:4.86mb | 下载:0

[VHDL编程registerarm_091220004cx

说明:32位arm寄存器的工程文件,包括代码及仿真-32-bit arm registers the project file, including code and simulation
<曹翔> 在 2025-06-04 上传 | 大小:3.51mb | 下载:0

[VHDL编程IRIGB_timecode

说明:irig time code for vhdl development
<AKHI> 在 2025-06-04 上传 | 大小:348kb | 下载:0

[VHDL编程VHDL

说明:设计一个准确地反映按键数字具有8位显示的电话按键显示器,该电话显示器要求具有重拨的功能,当按下重拨键时,能够显示最后一次输入的电话号码。-Accurately reflect the key to design a digital telephone with eight buttons the display shows the phone display requires a redial function, when you press the redial button, it will
<zz> 在 2025-06-04 上传 | 大小:46kb | 下载:0

[VHDL编程CPL

说明:CPLD技术在脱靶量测量中的研究CPLD technology in the miss distance measurement in the study-CPLD technology in the miss distance measurement in the study
<pass> 在 2025-06-04 上传 | 大小:223kb | 下载:0

[VHDL编程DDS

说明:DDS技术在正弦信号发生器中的应用DDS technology in the application of sinusoidal signal generator-DDS technology in the application of sinusoidal signal generator
<pass> 在 2025-06-04 上传 | 大小:435kb | 下载:0

[VHDL编程dds

说明:基于DDS的正弦波发生器 调制波发生器,能实现实时调幅,并在示波器上显示,还能测出各自的频率-Sine wave generator based on DDS modulation wave generator, to achieve real-time amplitude and displayed on an oscilloscope, but also measured the frequency of them
<shimaomao> 在 2025-06-04 上传 | 大小:178kb | 下载:0

[VHDL编程shizizhong

说明:利用QuartusII7.0、MATLAB以及SmartSOPC实验系统进行多功能数字钟的设计是本次试验的主要内容。该数字中需包含的功能主要有:分频、校时校分、清零、动态显示、整点报时、闹钟闹铃、秒表以及24小时制和12小时制的转换等。-QuartusII7.0, MATLAB, and SmartSOPC experimental system for the design of multi-function digital clock is the main content of the t
<shimaomao> 在 2025-06-04 上传 | 大小:249kb | 下载:0

[VHDL编程ound

说明:FPGA与PCI_E总线在声靶控制器中的应用-FPGA and PCI_E bus controller of the target sound
<> 在 2025-06-04 上传 | 大小:490kb | 下载:0
« 1 2 ... .78 .79 .80 .81 .82 1983.84 .85 .86 .87 .88 ... 4310 »

源码中国 www.ymcn.org