资源列表

« 1 2 ... .79 .80 .81 .82 .83 3284.85 .86 .87 .88 .89 ... 4310 »

[VHDL编程pro019

说明:ChipScope使用示例 简介:本示例中使用了一个ChipScope IP,将BIT文件配置到FPGA中后,可以启动 ChipScope Pro Analyer 捕获FPGA中数据,并显示如图所示。 -Example use ChipScope Introduction: this example uses a ChipScope IP, the BIT file configuration in the FPGA, you can start the ChipSc
<guoda> 在 2025-06-06 上传 | 大小:920kb | 下载:0

[VHDL编程VhdlPansong

说明:一本关于vhdl的入门书籍,适用于初学者或者刚刚入门的硬件工程师 -VHDL an entry on the books for beginners just getting started or hardware Engineer
<周洲> 在 2025-06-06 上传 | 大小:920kb | 下载:0

[VHDL编程fft

说明:基于FPGA的FFT的硬件实现。其中含有部分vhdl程序,本论文采用基4FFT算法-FPGA-based hardware implementation of the FFT. Vhdl part which contains the procedures used in this paper-based algorithm 4FFT
<xyyj> 在 2025-06-06 上传 | 大小:920kb | 下载:0

[VHDL编程DSB3

说明:利用ISE软件编写的Verilog程序,可以进行信号的双边带调制-Using ISE software program written in Verilog, can be bilateral with a modulation signal
<蜡笔> 在 2025-06-06 上传 | 大小:920kb | 下载:0

[VHDL编程uart

说明:基于verilog HDL编写的串口通讯接口uart程序-Prepared based on verilog HDL uart serial communication interface program
<张建> 在 2025-06-06 上传 | 大小:920kb | 下载:0

[VHDL编程openPOWERLINK_openMAC_v1.5.9.6

说明:powerlink工业以太网协议FPGA解决方案,-FPGA of powerlink protocol
<pengxing> 在 2025-06-06 上传 | 大小:920kb | 下载:0

[VHDL编程uart_regs

说明:an uart example for verilog-an example for verilog
<chenxiao> 在 2025-06-06 上传 | 大小:920kb | 下载:0

[VHDL编程uart_regs

说明:通过动手实践,熟悉使用Quartus II设计FPGA的方法-By hands-on practice, familiar with the method of using Quartus II design FPGA
<凉均兄> 在 2025-06-06 上传 | 大小:920kb | 下载:0

[VHDL编程RGLight

说明:本程序是基于VHDL的模拟交通灯程序,程序开发环境为ISE-This program is based on the the VHDL simulation traffic lights program, the program development environment for ISE
<王丽莉> 在 2025-06-06 上传 | 大小:920kb | 下载:0

[VHDL编程calculator

说明:利用verilog和vhdl两种语言写作的计数器,还有个性化设计模块,利用quartusii平台写作。-Use verilog and vhdl counter writing in two languages, as well as personalized design module, using the platform quartusii writing.
<程煜河> 在 2025-06-06 上传 | 大小:919kb | 下载:0

[VHDL编程fft256

说明:利用FPGA ip核实现256点的FFT转换,用vhdL语言实现。-Use FPGA ip core to achieve the 256-point FFT conversion with vhdL language.
<贺风> 在 2025-06-06 上传 | 大小:919kb | 下载:0

[VHDL编程4.LED_SHIFT

说明:xilinx led shift vhdl program
<forestgump> 在 2025-06-06 上传 | 大小:919kb | 下载:0
« 1 2 ... .79 .80 .81 .82 .83 3284.85 .86 .87 .88 .89 ... 4310 »

源码中国 www.ymcn.org